Mitigating the Clipping Noise by Using the Oversampling Scheme in OFDM Systems
نویسندگان
چکیده
In an Orthogonal Frequency Division Multiplexing (OFDM) systems, the Peak to Average power Ratio (PAR) is high. The clipping signal scheme is a useful and simple method to reduce the PAR. However, it introduces additional noise that degrades the systems performance. We propose an oversampling scheme to deal with the received signal in order to reduce the clipping noise by using finite impulse response (FIR) filter. Coefficients of filter are obtained by correlation function of the received signal and the oversampling information at receiver. The performance of the proposed technique is evaluated for frequency selective channel. Results show that the proposed scheme can mitigate the clipping noise significantly for OFDM systems and in order to maintain the system’s capacity, the clipping ratio should be larger than 2.5. Keywords—Orthogonal Frequency Division Multiplexing (OFDM), peak-to-average power ratio (PAR), oversampling.
منابع مشابه
A novel power-efficient scheme asymmetrically and symmetrically clipping optical (ASCO)-OFDM for IM/DD optical systems
In this paper, we propose a novel scheme of orthogonal frequency division multiplexing (OFDM) for intensity modulation direct detection (IM/DD) optical systems. By using this novel scheme of an OFDM optical system, not only odd subcarriers but also even subcarriers can be modulated to transmit a clipping optical signal. A conventional asymmetrically clipping optical (ACO)-OFDM is applied to mod...
متن کاملClipping Noise Cancellation for OFDM and OFDMA Systems Using Compressed Sensing
In this paper, we propose clipping noise cancellation scheme using compressed sensing (CS) for orthogonal frequency division multiplexing (OFDM) systems. In the proposed scheme, only the data tones with high reliability are exploited in reconstructing the clipping noise instead of the whole data tones. For reconstructing the clipping noise using a fraction of the data tones at the receiver, the...
متن کاملRecovering the Clipped OFDM Figurebased on the Conic Function
In Orthogonal Frequency Division Multiplexing (OFDM) systems, the peak to average power ratio (PAR) is much high. The clipping signal scheme is a useful method to reduce PAR. Clipping the OFDM signal, however, increases the overall noise level by introducing clipping noise. It is necessary to recover the figure of the original signal at receiver in order to reduce the clipping noise. Considerin...
متن کاملPerformance Analysis in ACO-OFDM based OWC Systems by Mitigating Clipping Noise
OFDM transmission in optical wireless channel is established via asymmetrically clipped optical OFDM (ACO-OFDM). Clipping is one of the simplest methods to reduce the high peak to average power ratio (PAPR). Clipping leads to additional in-band distortion and out-of band distortion. In this paper it is proposed to mitigate the clipping noise by iterative reconstruction based method and Channel ...
متن کاملReducing Timing Jitter in OFDM Systems Using Oversampling
Timing jitter is a major issue in very high speed OFDM systems, which causes serious impairments that, degrades the performance of overall system. In order to reduce the effect caused by timing jitter, here in this proposal, we introduced a novel scheme that reduces the noise caused by the effect of timing jitter by using integral oversampling under different channel environments such as AWGN, ...
متن کامل