3D eclipse mapping
نویسنده
چکیده
A light curve modelling and fitting program is presented for cataclysmic variable stars and related objects. It allows modelling of a three-dimensional disk in conjunction with the Roche-lobe filling secondary star, thus rendering it a very general tool for light curve analysis. Optimization of the solution is based on the maximumentropy algorithm. Some bench-mark tests are presented, and the general applicability of the program is explored. The program is used here to study the problem of reconstructing the brightness distribution on flaring accretion disks from eclipse light curves, and the results are compared with those obtained using the well-established standard technique of flat-disk eclipse mapping. A previous study suggested that erroneous radial temperature profiles were obtained with flat-disk eclipse mapping. It is shown here that flat-disk eclipse mapping does reproduce the radial brightness structure of flared accretion disks very well, provided that the inner disk is not obscured by the outer rim of the disk.
منابع مشابه
Spectral registration of noisy sonar data for underwater 3D mapping
3D mapping is very challenging in the underwater domain, especially due to the lack of high resolution, low noise sensors. A new spectral registration method is presented that can determine the spatial 6 DOF transformation between pairs of very noisy 3D scans with only partial overlap. The approach is hence suited to cope with sonar as the predominant underwater sensor. The spectral registratio...
متن کامل3D Modelling of Under Ground Burried Objects Based on Ground Penetration Radar
There is a growing demand for mapping and 3D modelling of buried objects such as pipelines, agricultural hetitage, landmines and other buried objects. Usually, large scale and high resolution maps from these objects are needed. Manually map generation and modeling of these objects are cost and time consuming and is dependent on lots of resources. Therefore, automating the subsurface mapping and...
متن کاملWhat can we learn from Accretion Disc Eclipse Mapping experiments?
The accretion disc eclipse mapping method is an astrotomographic inversion technique that makes use of the information contained in eclipse light curves to probe the structure, the spectrum and the time evolution of accretion discs in cataclysmic variables. This paper presents examples of eclipse mapping results that have been key to improve our understanding of accretion physics.
متن کاملDosimetric Comparison of 3D Tangential Radiotherapy of Post-Lumpectomy Breast at Two Different Energies
Introduction: Radiation therapy following breast conserving surgery is one of the most common procedures performed in any radiation oncology department. A tangential parallel-opposed pair is almost always the technique of choice for this purpose. This technique is often performed based on 3D treatment planning. The aim of this study was to compare 3D treatment planning for two different energie...
متن کاملMapping Specification in MDA: From Theory to Practice
In this paper, we present a metamodel for supporting the mapping specification between two metamodels. A mapping model based on this proposed metamodel defines correspondences between elements from two metamodels. It can then be used to generate a transformation definition, e.g. using Atlas Transformation Language (ATL). This metamodel is based on the Eclipse Modeling Framework (EMF). A plug-in...
متن کامل