A Shovel With a Perforated Blade Reduces Energy Expenditure Required for Digging Wet Clay

نویسندگان

  • Sridhar Harivanam
  • Richard W. Marklin
  • Paula E. Papanek
  • Vikram Cariapa
چکیده

OBJECTIVE A shovel with a blade perforated with small holes was tested to see whether a worker would use less whole-body energy to dig wet clay than with a shovel with an opaque blade. BACKGROUND A perforated shovel is hypothesized to require less whole-body energy on the basis of adhesion theory; a smaller surface area would require less physical effort to dig and release soil from the blade. METHOD The study involved 13 workers from an electric utility who dug wet clay with two 1.5-m long-handled point shovels, which differed only in blade design (perforated and opaque). Oxygen consumption was measured with a portable system while each worker dug wet clay at a self-regulated pace for 10 min. RESULTS There was no significant difference in number of scoops dug during the 10-min sessions, but workers dug 9.5% more weight of clay with the perforated shovel than with the conventional shovel (404 kg vs. 369 kg, respectively). Furthermore, stable oxygen uptake normalized to weight of participant and to the weight of clay dug revealed that participants expended 11.7% less relative energy per kilogram of clay dug with the perforated shovel. CONCLUSION A point shovel with a perforated blade is recommended for digging and shoveling wet clay. However, the extra weight that workers chose to dig with the perforated shovel may increase the loading on the spine and may offset the metabolic advantages. APPLICATION Manual shoveling is a common task, and workers may experience less whole-body and muscle fatigue when using a perforated shovel.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Analytical model for estimation of digging forces and specific energy of cable shovel

An analytical algorithm for the estimation of the resistance forces exerted on the dipper of a cable shovel and the specific energy consumed in the cutting-loading process is presented. Forces due to payload and to cutting of geomaterials under given initial conditions, cutting trajectory of the bucket, bucket’s design, and geomaterial properties are analytically computed. The excavation proces...

متن کامل

بررسی آزمایشگاهی عملکرد میان قاب های مصالح بنایی در قاب های بتنی

An experimental study is conducted on three ½ scales, single-story, single-bay, frame specimens. The first specimen was a reinforced concrete frame with solid-brick infill. The second specimen was a reinforced concrete frame with hollow clay perforated-brick infill. The last specimen was a reinforced concrete frame without any infill. These three specimens were tested by pseudostatic method. Di...

متن کامل

Wave Energy Dissipation Using Perforated and Non Perforated Piles

The indispensable vital structure in any harbor is a breakwater in order to make available calm water region inshore. Pile breakwater can be employed as a small coastal protection structure where tranquility required is low. This study is concerned with CFD study on the performance of perforated hollow pile to dissipate wave energy and the novelty of this investigation is the role of perforatio...

متن کامل

Continuity in Software Systems

Most engineering artifacts behave in a continuous fashion, and this property is generally believed to underlie their dependability. In contrast, software systems do not have continuous behavior, which is taken to be an underlying cause of their undependability. The theory of software reliability has been questioned because technically the sampling on which it is based applies only to continuous...

متن کامل

Experimental Investigation ofthe Hovering Performance of aTwin-Rotor Test Model

Hover performance of a twin-rotor test model in terms of rotor overlap sweep, blade collective pitch, and blade tip speedwasexaminedexperimentally.The experimental setup consisted of two three-bladed rotors (tandem rotor configuration) with a diameter of1,220 mm and constant chord of 38 mm, giving a blade aspect ratio of 16.05. The blades were of a rectangular planform with NACA 0012 cross-sect...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Human factors

دوره 52 4  شماره 

صفحات  -

تاریخ انتشار 2010