Turbulence Models Generator

نویسنده

  • Victor Yakhot
چکیده

In this paper we explore a possibility that all transport turbulent models are contained in a coarse-grained kinetic equation. Building on a recent work by H.Chen et al (2004), we account for fluctuations of a single -point probability density in turbulence, by introducing a“two-level” ( c,v)-phase-space, separating microscopic (c ≡ cmicro = c− v) and hydrodynamic (v = v −V) modes. Unlike traditional kinetic theories, with hydrodynamic approximations derived in terms of small deviations from thermodynamic equilibrium, the theory developed in this work, is based on a farfrom -equilibrium isotropic and homogeneous turbulence as an unperturbed state. The expansion in dimensionless rate of strain leads to a new class of turbulent models, including the well-known K − E , Reynolds stress and all possible nonlinear models. The role of interaction of the fluxes in physical space with the energy flux across the scales, not present in standard modeling, is demonstrated on example of turbulent channel flow. To close the system, neither equation for turbulent kinetic energy nor information on pressure-velocity correlations, contained in the derived coarse-grained kinetic equation, are needed.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Internal combustion engines in cylinder flow simulation improvement using nonlinear k-ε turbulence models

The purpose of this paper is to studying nonlinear k-ε turbulence models and its advantages in internal combustion engines, since the standard k-ε model is incapable of representing the anisotropy of turbulence intensities and fails to express the Reynolds stresses adequately in rotating flows. Therefore, this model is not only incapable of expressing the anisotropy of turbulence in an engine c...

متن کامل

Turbulence Model Analysis of Flow inside a Hydrocyclone

Turbulence analysis of flow inside a hydrocyclone is carried out using commercially available CFD software ANSYS-CFX (release 11.0). Commercial CFD software(s) and their turbulence models have come a long way in accurately predicting the flow inside a hydrocyclone, both at the mean as well as at the turbulence level. Previous studies have shown, the more accurate the turbulence prediction is, t...

متن کامل

Comparison of different turbulence models in a high pressure fuel jet

In this study, modeling of a fuel jet which has been injected by high pressure into a low-pressure tank are investigated. Due to the initial conditions and the geometry of this case and similar cases (like CNG injectors in internal combustion engines (ICE)), the barrel shocks and Mach disk are observed. Hence a turbulence and transient flow will be expected with lots of shocks and waves. Accord...

متن کامل

Flow Field Characteristics of an Aerospike Nozzle Using Different Turbulence Models

To improve the calculation of the flow properties of an aerospike nozzle, different turbulence models were investigated in this study. The primary shape of the nozzle plug is determined through utilizing an approximate method. The flow field is, then, simulated using the Navier-Stokes equations for compressible flows. The commercial computational fluid dynamics code Fluent is used to simulate t...

متن کامل

Effect of Different Turbine-generator Shaft Models on the Subsynchronous Resonance Phenomenon in the Double Cage Induction Generator Based Wind Farm

This paper focuses on the turbine-generator shaft models of double-cage Induction Generator (IG) based wind farm and its influence on the sub-synchronous resonance phenomenon. For this purpose, six different shaft models as 6-mass, 4-mass, 3-mass I, 3-mass II, 2-mass and 1-mass models are considered for double-cage IG wind-turbine. By using the linear modal analysis method, the effects of the d...

متن کامل

Numerical Predictions of Turbulent Mixed Convection Heat Transfer to Supercritical Fluids Using Various Low Reynolds Number k-e Turbulence Models

There are a number of systems in which supercritical cryogenic fluids are used as coolants or propellant fluids. In some modern military aircraft, the fuel is pressurized above its critical point and used as a coolant to remove heat from the aircraft engine. Accurate prediction of heat transfer coefficients to turbulent flows of supercritical fluids is essential in design of such systems. One o...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2008