Strain-induced 13C chemical shift change of natural rubber
نویسندگان
چکیده
We investigated the effect of deformation of natural rubbers (NR) resulting from the high centrifugal pressure of fast magicangle spinning (MAS) on 13C NMR spectra. The solid state 13C MAS NMR spectrum with high-power 1H dipolar decoupling (DD) of NR presents liquid-like, very narrow signals (full width at half height, FWHH, is less than 10 Hz). However, the static state 13C DD NMR spectrum of the NR after MAS presented broad and apparently anisotropic peaks for the restricted elongated (doughnut-shaped) NR (FWHH is approximately 280 Hz), although the static 13C NMR spectrum before MAS exhibited an isotropic and relatively narrow peak (FWHH is 150 Hz). Furthermore, the 13C DD NMR peaks of the maximum elongated NR in a rotor apparently became a doublet. The static 13C DD NMR spectrum of a strip cut from the maximum elongated NR showed an angle dependence to the static magnetic field, and the dependence was explained from the molecular orientation. The angle-dependent 13C NMR spectra of a strip cut from the doughnut-shaped NR differed from those of the maximum elongated NR. The magnetization measured using a SQUID (superconducting quantum interference device) indicated that the magnetic susceptibility of the strip cut from the doughnut-shaped NR was different from the maximum elongated (rolled) NR. The difference in the angle dependence of the 13C DD NMR spectra was therefore attributed to not only the molecular orientation but also the difference in magnetic susceptibility caused by the p electron interaction with the static magnetic field. Polymer Journal (2012) 44, 778–785; doi:10.1038/pj.2012.120; published online 20 June 2012
منابع مشابه
The Conformational Effect of 6-Mono-Substituted and 6,7-Di-Substituted Derivatives of 5,6,7,8-Tetrahydrodibenzo[a,c]cyclo-octene on 13C Chemical Shift
Hartree-Fock (HF) and Density Functional Theory (DFT) methods employed to study the effect of conformational change on the 13C chemical shifts of 6-mono axial and equatorial substituted and 6,7-di axial-axial, equatorial-equatorial and axial-equatorial substitutedderivatives of 5,6,7,8-tetrahydrodibenzo[a,c]cyclo-octene. The geometry of the conformers have been optimized...
متن کاملThermodynamics, Solvents effects and 1H ,13C NMR Shielding :Theoretical studies of Adamantane
Some of the Adamantane properties were calculated in this study. Chemical shift, free energy ofsolvation, free energy of cavity formation, Henry's law constant, and other properties ofAdamantane in dry phase, three solvents and three temperatures have been calculated with Abinitio method base on density functional theory (DFT) at B3lyp/6-31g, B31yp/6-31g*, B3lyp/6-31+g* and B3lyp/6-31++g** leve...
متن کاملA Micro-Mechanically Based Continuum Model for Strain-Induced Crystallization in Natural Rubber
Recent experimental results show that strain-induced crystallization can substantially improve the crack growth resistance of natural rubber. While this might suggest superior designs of tires or other industrial applications where elastomers are used, a more thorough understanding of the underlying physics of strain-induced crystallization in natural rubber has to be developed before any desig...
متن کاملQuantum Chemical Modeling of N-(2-benzoylphenyl)oxalamate: Geometry Optimization, NMR, FMO, MEP and NBO Analysis Based on DFT Calculations
In the present work, the quantum theoretical calculations of the molecular structure of the (N-(2-benzoylphenyl) oxalamate has been investigated and are evaluated using Density Functional Theory (DFT). The geometry of the title compound was optimized by B3LYP method with 6-311+G(d) basis set. The theoretical 1H and 13C NMR chemical shift (GIAO method) values of the title compound are calculated...
متن کاملThe Cyclization of Natural Rubber
The effects of solvent, temperature, time, weight percent of catalyst on the rate and mechanism of cyclization of natural rubber (NR) was studied in toluene and xylene solutions having tin tetra chloride catalyst (SnCl4). Iodometric titration show, with 8% SnCl4 (based on polymer weight) cyclization occurs, leaving 27.4% of the total unsaturation. Infrared spectra of c...
متن کامل