induction motor broken bar diagnosis using vibration spectrum in the presence of obtrusive frequency components
نویسندگان
چکیده
different methods for detecting broken bars in induction motors can be found in literature. many of these methods are based on evaluating special frequency magnitudes in machine signals spectrums. current, power, flux, etc are among these signals. frequencies related to broken rotor fault depend on slip. in industrial environment due to some phenomena - such as load oscillation, other faults and disturbances – obtrusive frequency components appear in the vicinity of fault components; therefore, correct diagnosis of fault depends on accurate determination of motor velocity and slip. the traditional methods typically require several sensors that should be pre-installed in some cases. this paper presents a diagnosing method based on vibration spectrum. motor velocity oscillation due to broken rotor causes frequency components at twice slip frequency (2sf) difference around speed frequency in vibration spectrum. speed frequency and its harmonics as well as twice supply frequency, can easily and accurately be found in vibration spectrum, therefore the motor slip can be computed. now components related to rotor fault can be found. evaluation of these fault components magnitudes can be a good measure for fault diagnosis.
منابع مشابه
An Experimental Investigation on Broken Rotor Bar in Three Phase Induction Motor by Vibration Signature Analysis using MEMS Accelerometer
Three phase Squirrel Cage Induction Motors (SCIM) are continuously subjected to electrical, thermal, mechanical and environmental stresses in any industrial application. Such stresses can result in rotor bar damage. Due to such faults an unsymmetrical magnetic field will be setup and can lead to reduction in developed torque, increase in speed fluctuations, noise and vibrations. The present wor...
متن کاملDetection of Broken Rotor Bar Fault in Induction Motor Using Paramter Estimation Approach
The detection of faults in a dynamic system can help to avoid severe damage where system reliability and safety are essential. An induction motor can fail either due to internal faults such as short circuit of motor leads; broken rotor bar and cracked rotor end rings or by external faults such as phase failure, asymmetry of main supply and mechanical overload (Karami et al 2010). Detection and ...
متن کاملNew Features from Fourier Spectrum for Induction Machine Broken Bar Detection Using Statistical Pattern Recognition
A fault diagnosis system based on pattern recognition techniques is developed for cage induction machine broken bar detection. The developed algorithm uses the stator current and, if available, motor speed as input data. Several features are extracted from the Frequency spectrum of the current signal derived using the Fast Fourier Transform. The relevance of the features for the purpose of faul...
متن کاملSimultaneous Detection of Broken Rotor Bar Fault and PQ disturbances in the Supply to Induction Motor Using Neuro-Fuzzy
This paper presents a methodology for the detection of broken rotor bar fault and power quality (PQ) disturbances in the supply to induction motor. These faults lead to increase in the temperature and decrease in the efficiency of the induction motor. Wavelet transform is applied to the stator current, for the extraction of the signature of the fault. These wavelet coefficients are fed as input...
متن کاملSeparation Harmonics to Discern Broken Bar Fault from Load Torque Oscillation in Three Phase Induction Motor
This paper presents separation harmonics to discriminate rotor failure from low frequency load torque oscillations in three phase induction motors. The most common method for detecting broken rotor bar faults is to analyze the corresponding sidebands through motor current signature analysis (MCSA). If a motor is subjected to load fluctuation, then the oscillation related sidebands exhibit simil...
متن کاملمنابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
the modares journal of electrical engineeringناشر: tarbiat modares university
ISSN 2228-527 X
دوره 7
شماره 1 2008
کلمات کلیدی
میزبانی شده توسط پلتفرم ابری doprax.com
copyright © 2015-2023