surge control in constant speed centrifugal compressors using nonlinear model predictive control

نویسندگان

masoud taleb ziabari

mohammad reza jahed motlagh

karim salahshoor

amin ramazani

چکیده

surge is one of the two destructive factors in compressors. surge is the stream instability phenomenon in compressor that imposes severe damages to the compressors. nowadays, suppressingsurge phenomenon is one of the most important issues in oil and gas industries, especially when flow reduction or gas reflux is considered. according to moore-greitzer compressor model, this paper designs an active controller for surge control in constant speed centrifugal compressors. as such, the applied operator considered for surge control is close couple valve (ccv) and it is designed to stabilize a centrifugal compressor system with disturbaces using nonlinear predictive controller. the proposed controller, without any information about the amount of throttle valve variations, could control the surge instability and reduce the distance between compressor operation point and the surge line. finally, the compressor system with controller is simulated and the obtained results will show the efficiency of the designed nonlinear predictive controller

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Model Predictive Anti-Surge Control of Centrifugal Compressors with Variable-Speed Drives

In this article torque assisted anti-surge control (TASC), a compressor anti-surge control system based on model predictive control (MPC) is presented. TASC is implemented on an embedded system for the control of compressor stations with electrical variable-speed drives (VSD) which are used in applications such as natural gas transportation via pipelines. The manipulated variables of the propos...

متن کامل

Active surge control of centrifugal compressors using drive torque

A novel aproach to active surge control is presented. A centrifugal compressor driven by an electrical motor is studied, and the drive itself is used for surge control, thus elliminating the need for additional actuators. It is shown that by using the rotational speed of the motor as control, previous unstable operating points to the left of the surge line can be made globally exponentially sta...

متن کامل

Drive torque actuation in active surge control of centrifugal compressors

A novel aproach to active surge control is presented for a centrifugal compressor driven by an electrical motor. The main idea of the paper is to use the drive itself for surge control. This eliminates the need for additional actuators, and has the potential of energy efficient operation. It is shown that previous unstable operating points to the left of the surge line can be made globally expo...

متن کامل

Centrifugal compressor surge and speed control

Previous work on stabilization of compressor surge is extended to include control of the angular velocity of the compressor. First a low-order centrifugal compressor model is presented where the states are mass flow, pressure rise, and rotational speed of the spool. Energy transfer considerations are used to develop a compressor characteristic. In order to stabilize equilibria to the left of th...

متن کامل

Supercritical fluid recycle for surge control of CO2 centrifugal compressors

This paper presents computer-based design and analysis of control systems for centrifugal compressors when the operating fluid is supercritical CO2. It reports a non-linear dynamic model including a main forward compression line and two different configurations for the recycle antisurge line. Disturbance scenarios are proposed for testing the configurations and performance indicators are sugges...

متن کامل

Control of centrifugal compressors via model predictive control for enhanced oil recovery applications

This paper proposes a control system for integrated pressure and surge control of centrifugal compressors for enhanced oil recovery application. The proposed control system is based on linear model predictive control. A fully validated non-linear dynamic model was developed in order to simulate the operation of the compressor at full and partial load. The model of the compression system include...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید


عنوان ژورنال:
the modares journal of electrical engineering

ناشر: tarbiat modares university

ISSN 2228-527 X

دوره 12

شماره 1 2015

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023