lab and field scale modeling of near miscible co2 injection in different porous mediums

Lab and Field Scale Modeling of Near Miscible CO2 Injection in Different Porous Mediums

The main purpose of this investigation is to study the effect of near miscible CO2 injection in different porous mediums on both lab and field scales. This effect can be traced by the change of two-phase gas-oil relative permeability curves. In this work, the experiments have been performed on three rock types (i.e. sandstone, dolomite, and artificial fractured sandstone) based on an incrementa...

simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water

abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...

Miscible porous media displacements driven by non-vertical injection wells

High-resolution simulations are employed to identify and analyse the mechanisms dominating miscible porous media displacements generated by inclined injection wells. Compared to vertical injection wells, significant differences are observed that strongly influence breakthrough times and recovery rates. Constant density and viscosity displacements, for which the velocity field is potential in na...

Experimental Investigation on Asphaltene Deposition in Porous Media During Miscible Gas Injection

In this work the likelihood of asphaltene deposition problems during dynamic displacement of oil by natural gas in unconsolidated porous media is experimentally inspected. The two different rock materials, limestone and sandstone, are used as a representative of porous media. Dynamic flow experiments indicate that the increase of natural gas injection inc...

Modeling and Simulation of Alternative Injections of CO2 and Water into Porous Carbonate Formations

Water alternating gas (WAG) technique is used in the petroleum industry to inject carbon dioxide (CO2) into underground formations either for sequestration or enhanced oil recovery (EOR) processes. CO2 injection causes reactions with formation brine or aquifer and produces carbonic acid, the acid dissolves calcite and changes flow behavior significantly. Modeling and investigating effects of CO...

Instability Analysis of Miscible Displacements in Homogeneous Porous Media