affect of age on composite bond strength to dentine using 5th and 6th generation adhesive system
نویسندگان
چکیده
abstract introduction: the mineral content of dentin increases with age and its primary structure is altered. these changes may have unknown effects on efficiency of adhesive systems. the aim of this study was to find the effect of aging on dentin bonding agents. methods and materials: fourty eight extracted human premolars were divided into 2 groups under 15 years old & 2 groups over 45 years old. after exposing surface dentin with wheel type burs and polishing dentin surface with paper disks, dental adhesives, excite & prompt l-pop were used following manufacturer’s instructions. then composite cylinders were bonded to dentin & light cured. then shear bond strength (sbs) of samples were measured with universal testing device (dartec). fractured specimens were observed under stereomicroscope to determine the type of fracture. results: the mean sbs for those teeth aged over 45 was 24.15 mpa using prompt l-pop, and 18.6 mpa using excite, and for teeth aged under 15 years old was 21.5 mpa using prompt l-pop and 13.99 mpa using excite. conclusion: sbs of older teeth was shown to be more than younger teeth, also prompt l-pop showed higher sbs than excite. it seems that lower mineral content of dentin in younger teeth results in over demineraliza-tion while etching hence resin is unable to penetrate the collagens fibers resulting in voids in bonding area which reduces the sbs in this group. also higher sbs of prompt l-pop can be explained by the water cone-tent of it, which serves as solvent while excite has ethanol which is evaporated and reduces the penetration of resin.
منابع مشابه
Bond Strength of 5th, 6th and 7th Generation Bonding Agents to Intracanal Dentin of Primary Teeth
OBJECTIVES This in-vitro study sought to assess the push-out bond strength of a total etch and 2 self-etch bonding systems to intracanal dentin of primary anterior teeth (PAT). MATERIALS AND METHODS Thirty-six primary anterior teeth were randomly divided into 3 groups of 5(th) generation (Single Bond 2), 6(th) generation (Clearfil SE) and 7(th) generation (Single Bond Universal) bonding agent...
متن کاملInfluence of 10-MDP Adhesive System on Shear Bond Strength of Zirconia-Composite Interfaces
Introduction: This in-vitro study investigated the initial 24h bond strength between different composites and zirconia after application of four different adhesive systems. Methods: A total of 120 specimens of zirconia (InCoris, Sirona, Germany, Bernsheim) were ground with a 165 µm grit rotating diamond disc. Thirty specimens were each additionally treated with Cimara Zircon “CZ” (VOCO GmbH, ...
متن کاملAdhesive system affects repair bond strength of resin composite
Purpose This study evaluated the effects of different adhesive systems on repair bond strength of aged resin composites. Materials and Methods Ninety composite discs were built and half of them were subjected to thermal aging. Aged and non-aged specimens were repaired with resin composite using three different adhesive systems; a two-step self-etch adhesive, a two-step total-etch adhesive and...
متن کاملShear bond strength of Composite / Amalgam restorations: Effect of using adhesive cement
Shear bond strength of Composite / Amalgam restorations: Effect of using adhesive cement Dr. M. Khoroushi *- Dr. M. Yeganehjo ** *Assistant Professor of Operative Dentistry & Dental Materials Dept., Faculty of Dentistry, Isfahan University of Medical Sciences. ** Dentist. Abstract Background and Aim: The aim of this study was to evaluate the shear bond strength (SBS) of composite/amalgam restor...
متن کاملEffect of Type of Surface Treatment and Adhesive System on Shear Bond Strength of Composite Resin to a Non-Precious Metal Alloy
Background and Aim: Fractured metal-ceramic restorations may be repaired with composite in some cases to postpone the fabrication of a new restoration. Knowledge about the bond strength can help predict the success rate of this treatment modality. The aim of this study was to assess the effect of two types of mechanical surface treatment of metal along with the use of different adhesive systems...
متن کاملMicrotensile bond strength of silorane-based composite specific adhesive system using different bonding strategies
OBJECTIVES The aim of this study was to evaluate the effect of pre-etching on the bond strength of silorane-based composite specific adhesive system to dentin. MATERIALS AND METHODS Thirty human molars were randomly divided into 5 groups according to the different bonding strategies. For teeth restored with silorane-based composite (Filtek Silorane, 3M ESPE), the specific self-etching adhesiv...
متن کاملمنابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
مجله دانشکده دندانپزشکی اصفهانجلد ۱، شماره ۳، صفحات ۰-۰
کلمات کلیدی
میزبانی شده توسط پلتفرم ابری doprax.com
copyright © 2015-2023