effect of different adhesive systems on microleakage at the amalgam/composite interface
نویسندگان
چکیده
abstract: introduction: ditching and marginal defects of amalgam restorations can cause microleakage, recurrent carries, pulp hypersensitivity and finally loss of the tooth. the complete replacement of large restoration is time consuming, difficult and may potentially damage the pulp. therefore in cases were there is no sings of recurrent caries, composite repair can be chosen as an alternative. the purpose of this study was to compare the effect of different bonding agent application on microleakage between flowable composite & amalgam. methods and materials: standard calss v amalgam preparations were prepared on 60 carries free premolars and the cavities were filled using amalgam. after 24 hours, a 1 mm cavity on the occlusal margin of the class v restorations was prepared and specimens were divided randomly into four treatment groups: first group was filled with flowable composite and single bond. second group was filled with flowable composite and se bond. third group was filled with flowable composite and prompt-l-pop. fourth group was filled with flowable composite without denting bonding agent. specimens were thermocycled and sealed with fingernail polish except the composite-amlagam interface, then immersed in basic fuchsine for 24 hours. specimens were sectioned and microleakage was assessed. the data were analyzed using kruskal-wallis test and mann-whitney u test. results: the results indicated that dentin bonding agent is effective in decreasing the degree of microleakage in amalgam-flowable composite interface and also the clearfil se bond was more effective than prompt-l-pop. but there was no significant statistical difference in microleakage between se bond and single bond. conclusion: the application of dentin bonding agents in repair of amalgam retoration using flowable composite decreases microleakage but more researches should be performed.
منابع مشابه
Microleakage at the composite-repair interface: effect of different adhesive systems.
The purpose of the present study was to evaluate the microleakage at the composite-repair interface using different bonding systems. Composite resin specimens (Filtek Z250 - 3M-ESPE) were divided into five groups (n=20) according to the following bonding mechanism: C - control - etching with 35% phosphoric acid; SB1 - etching and application of one coat of Single Bond (3M-ESPE); SB2 - etching a...
متن کاملEffect of operator variability on microleakage with different adhesive systems
OBJECTIVE The objective of this study was to evaluate the effect of operator variability on microleakage with different adhesive systems. MATERIALS AND METHODS A total of 180 standardized Class V cavities were prepared on facial and lingual of 90 extracted human premolar teeth and randomly assigned to five groups according to the adhesive systems used (n = 36): Prime and Bond NT (PB), Single ...
متن کاملEffect of Thermocycling on Microleakage of New Adhesive Systems on Primary Teeth: An In-Vitro Study
Introduction: This study investigated the sealing ability of three different adhesives in primary bovine teeth. Methods: Facial and lingual class V cavities were prepared half in enamel and half in cementum, in 48 bovine primary mandibular incisors and randomly divided into three groups and each group divided to two subgroups. The tested adhesives were XPBond (XP), ClearfilS3 Bond (S3), and Xen...
متن کاملEvaluation of Different Dentin Adhesive Systems and its Effect on Apical Microleakage: An In Vitro Study
BACKGROUND Regardless of the technique and the material used, the goal of obturation remained the same that is to seal every portal of exit in the root canal system. It's not only the apical openings that need to be sealed but also lateral openings, coronal access opening and perforations if they exist failure of the adhesive root canal sealer has led to the idea of usage of dentin bonding agen...
متن کاملMicroleakage under orthodontic brackets bonded with different adhesive systems
OBJECTIVE This in vitro study aimed to compare the microleakage of orthodontic brackets between enamel-adhesive and adhesive-bracket interfaces at the occlusal and gingival margins bonded with different adhesive systems. MATERIALS AND METHODS A total of 144 human maxillary premolar teeth extracted for orthodontic reasons was randomly divided into four groups. Each group was then further divid...
متن کاملthe washback effect of discretepoint vs. integrative tests on the retention of content in knowledge tests
در این پایان نامه تاثیر دو نوع تست جزیی نگر و کلی نگر بر به یادسپاری محتوا ارزیابی شده که نتایج نشان دهندهکارایی تستهای کلی نگر بیشتر از سایر آزمونها است
15 صفحه اولمنابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
مجله دانشکده دندانپزشکی اصفهانجلد ۱، شماره ۳، صفحات ۰-۰
کلمات کلیدی
میزبانی شده توسط پلتفرم ابری doprax.com
copyright © 2015-2023