root canal shaping by single-file systems and rotary instruments: a laboratory study

نویسندگان

khaly bane

babacar faye

mouhamed sarr

seydina o niang

چکیده

i ntroduction: the aim of this study was to compare the shaping ability of two single-file systems and conventional rotary instruments in severely curved root canals of extracted human molars. methods and materials: mesiobuccal canals of 120 mandibular molars with angles of curvature ranging between 25 ° and 35 ° and radii of curvature from 5 to 9 mm, were divided into three groups ( n =40). in each group the canals were instrumented with either waveone (w), reciproc(r) or protaper (p). the time required for canal shaping and the frequency of broken instruments were recorded. the standardized pre and post-instrumentation radiographs were taken to determine changes in working length (wl) and straightening of canal curvature. the presence of blockage or perforation was also evaluated. data were analyzed using the one-way analysis of variance (anova) and post-hoc tukey’s test. the level of significance was set at 0.05. results: both single-instrument systems reduced the canal preparation time by approximately 50% ( p <0.05). no incidence of broken instruments from single-file systems was reported; however, two f2 instruments in the p group were broken ( p <0.05). reduction in wl and straightening of canal curvature was observed in all three systems with the highest scores belonging to p system ( p <0.05). no case of blockage or perforation was found during shaping in any group. conclusion : single-file systems shaped curved canals with substantial saving in time and a significant decrease in incidence of instrument separation, change in wl, and straightening of canal curvature.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Root Canal Shaping by Single-File Systems and Rotary Instruments: a Laboratory Study

INTRODUCTION The aim of this study was to compare the shaping ability of two single-file systems and conventional rotary instruments in severely curved root canals of extracted human molars. METHODS AND MATERIALS Mesiobuccal canals of 120 mandibular molars with angles of curvature ranging between 25(°) and 35(°) and radii of curvature from 5 to 9 mm, were divided into three groups (n=40). In ...

متن کامل

comparison of postoperative pain after root canal preparation with two reciprocating and rotary single-file systems: a randomized clinical trial

introduction: root canal preparation techniques may cause postoperative pain. the aim of the present study was to compare the intensity of postoperative pain after endodontic treatment using hand files, single file rotary (oneshape), and single file reciprocating (reciproc) systems. methods and materials: in this single-blind, parallel-grouped randomized clinical trial a total of 150 healthy pa...

متن کامل

Debris Evaluation after Root Canal Shaping with Rotating and Reciprocating Single-File Systems

This study evaluated the root canal dentine surface by scanning electron microscope (SEM) after shaping with two reciprocating single-file NiTi systems and two rotating single-file NiTi systems, in order to verify the presence/absence of the smear layer and the presence/absence of open tubules along the walls of each sample; Forty-eight single-rooted teeth were divided into four groups and shap...

متن کامل

cone-beam computed tomography assessment of root canal transportation by neoniti and reciproc single-file systems

introduction: the aim of this in vitro study was to compare the canal transportation of two single-file engine-driven systems, neoniti and reciproc, using cone-beam computed tomography (cbct). methods and materials: forty-five non-calcified roots with mature apices and apical curvature of 15-30 degrees were selected from extracted human maxillary molars for this study. samples were randomly div...

متن کامل

Dentinal microcrack formation during root canal preparations by different NiTi rotary instruments and the self-adjusting file.

INTRODUCTION The purpose of this study was to compare dentinal microcrack formation while using hand files (HFs), 4 brands of nickel-titanium (NiTi) rotary files and the self-adjusting file. METHODS One hundred forty mandibular first molars were selected: 20 teeth were left unprepared and served as control, and the remaining 120 teeth were divided into 6 groups. HFs, HERO Shaper (HS; Micro-Me...

متن کامل

Single file niti - rotary systems

IJMDS ● www.ijmds.org ● January 2015; 4(1) 701 Review Article Single file niti-rotary systems Kumar SR, Gade V ABSTRACT The cleaning and shaping of root canals is a major step in root canal treatment procedure, which aims at removal of all the tissue debris from the root canal space while removing the inner layers of root canal dentin. With Nickel titanium (NiTi) rotary instruments this goal is...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید


عنوان ژورنال:
iranian endodontic journal

جلد ۱۰، شماره ۲، صفحات ۱۳۵-۱۳۹

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023