four different types of a single drop dripping down a hole under gravity by lattice boltzmann method

نویسندگان

mohamad hasan rahimian

دانشیار دانشکده مهندسی مکانیک دانشگاه تهران reza haghani

phd student in school of mechanical eng.

چکیده

in this paper the dynamic of a droplet on a surface with a hole is investigated under gravitational effect by using lattice boltzmann method. incompressible two-phase flow with high density ratio proposed by lee is considered. cahn’s theory is used to observe the wettability of the surface in contact with liquid and gas phases. several parameters such as contact angle, surface tension and gravitational acceleration are studied to demonstrate their effects on the deformation of the droplet. to evaluate the results, the benchmark problems for equilibrium contact angle, capillary rise and laplace law are conducted and a satisfactory agreement with analytical results is shown. based on this study, four typical deformations of a droplet dripping down a hole can be observed; equilibrium drop on the top of the surface, equilibrium drop under the bottom of the surface, splashing and dripping of the drop. it is seen that at low ohnesorge numbers the droplet deforms slightly and tends to retain its state. moreover any increase in the archimedes number magnifies the tendency to pass through the hole. also, the relationship between the volume of the remaining droplet on the surface and archimedes and ohnesorge numbers is investigated. it is found that by increasing the archimedes number, the volume of the remaining droplet on the surface reaches a constant value that is dependent on geometric parameters.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Four different types of a single drop dripping down a hole under gravity by lattice Boltzmann method

In this paper the dynamic of a droplet on a surface with a hole is investigated under gravitational effect by using lattice Boltzmann method. Incompressible two-phase flow with high density ratio proposed by Lee is considered. Cahn’s theory is used to observe the wettability of the surface in contact with liquid and gas phases. Several parameters such as contact angle, surface tension and gravi...

متن کامل

Lattice Boltzmann Simulation of Deformation and Breakup of a Droplet under Gravity Force Using Interparticle Potential Model

Abstract In this paper interparticle potential model of the lattice Boltzmann method (LBM) is used to simulate deformation and breakup of a falling droplet under gravity force. First this model is applied to ensure that the surface tension effect is properly implemented in this model. Two tests have been considered. First, it has been checked an initial square drop in a 2D domain can freely def...

متن کامل

solution of security constrained unit commitment problem by a new multi-objective optimization method

چکیده-پخش بار بهینه به عنوان یکی از ابزار زیر بنایی برای تحلیل سیستم های قدرت پیچیده ،برای مدت طولانی مورد بررسی قرار گرفته است.پخش بار بهینه توابع هدف یک سیستم قدرت از جمله تابع هزینه سوخت ،آلودگی ،تلفات را بهینه می کند،و هم زمان قیود سیستم قدرت را نیز برآورده می کند.در کلی ترین حالتopf یک مساله بهینه سازی غیر خطی ،غیر محدب،مقیاس بزرگ،و ایستا می باشد که می تواند شامل متغیرهای کنترلی پیوسته و گ...

Numerical Simulation of Fluid Flow Past a Square Cylinder Using a Lattice Boltzmann Method

The method of lattice boltzmann equation(LBE) is a kinetic-based approach for fluid flow computations. In the last decade, minimal kinetic models, and primarily the LBE, have met with significant success in the simulation of complex hydrodynamic phenomena, ranging from slow flows in grossly irregular geometries to fully developed turbulence, to flow with dynamic phase transitions. In the presen...

متن کامل

Simulation of Lid Driven Cavity Flow at Different Aspect Ratios Using Single Relaxation Time Lattice Boltzmann Method

Abstract   Due to restrictions on the choice of relaxation time in single relaxation time (SRT) models, simulation of flows is generally limited base on this method. In this paper, the SRT lattice Boltzmann equation was used to simulate lid driven cavity flow at different Reynolds numbers (100-5000) and three aspect ratios, K=1, 1.5 and 4. The point which is vital in convergence of this scheme ...

متن کامل

Gravity in a lattice Boltzmann model

In this paper we consider the introduction of a body force, in the incompressible limit, into the lattice Boltzmann model. A number of methods are considered and their suitability to our objectives determined. When there is no density variation across the fluid, gravity can be introduced in the form of an altered pressure gradient. This method correctly satisfies the Navier-Stokes equation; how...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید


عنوان ژورنال:
journal of computational applied mechanics

جلد ۴۷، شماره ۱، صفحات ۸۹-۹۸

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023