3d finite element modeling for dynamic behavior evaluation of marin risers due to viv and internal flow

نویسندگان

madjid ghodsi hassanabad

marine industries group, science and research branch, islamic azad university, tehran, iran ajang fardad

marine industries group, science and research branch, islamic azad university, tehran, iran

چکیده

the complete 3d nonlinear dynamic problem of extensible, flexible risers conveying fluid is considered. for describing the dynamics of the system, the newtonian derivation procedure is followed. the velocity field inside the pipe formulated using hydrostatic and bernoulli equations. the hydrodynamic effects of external fluids are taken into consideration through the nonlinear drag forces in various time steps and the added inertia due to the hydrodynamic mass. following the newtonian derivation, the dynamics of the pipes element with effects of internal fluid are considered separately and the final governing set is derived by combining the equations of inertia equilibrium. the study focuses specifically on the effect of the inner flow to the global dynamics of the riser. this task is accomplished using time domain teachings and the finite element method is used as a powerful numerical method. moreover the euler-bernoulli beam theory is used response to model the dynamic behavior of the flexible risers.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

3D Finite element modeling for Dynamic Behavior Evaluation of Marin Risers Due to VIV and Internal Flow

The complete 3D nonlinear dynamic problem of extensible, flexible risers conveying fluid is considered. For describing the dynamics of the system, the Newtonian derivation procedure is followed. The velocity field inside the pipe formulated using hydrostatic and Bernoulli equations. The hydrodynamic effects of external fluids are taken into consideration through the nonlinear drag forces in var...

متن کامل

Monitoring VIV fatigue damage on marine risers

Long flexible cylinders (e.g. risers, tendons, mooring lines) exposed to the marine environment encounter ocean currents leading to vortex-induced vibration (VIV). These oscillations, often driven at high frequencies over extended periods of time may result in structural failure of the member due to fatigue damage accumulation. Recent developments in instrumentation and installation of data acq...

متن کامل

diagnostic and developmental potentials of dynamic assessment for writing skill

این پایان نامه بدنبال بررسی کاربرد ارزیابی مستمر در یک محیط یادگیری زبان دوم از طریق طرح چهار سوال تحقیق زیر بود: (1) درک توانایی های فراگیران زمانیکه که از طریق برآورد عملکرد مستقل آنها امکان پذیر نباشد اما در طول جلسات ارزیابی مستمر مشخص شوند; (2) امکان تقویت توانایی های فراگیران از طریق ارزیابی مستمر; (3) سودمندی ارزیابی مستمر در هدایت آموزش فردی به سمتی که به منطقه ی تقریبی رشد افراد حساس ا...

15 صفحه اول

A study on behavior of block pavement using 3D finite element method

Three dimensioned finite element analysis were conducted on concrete block paving. In order to verify the calculated results, an experimental case study was analyzed. Good agreement was observed between the measured and the calculated results. Based on the finite element analysis results and available failure models, comprehensive design charts were developed for port and industrial pavement wh...

متن کامل

Finite element modeling of blood flow: Relevance to atherosclerosis

Computational methods are emerging as powerful tools for quantifying blood flow in arteries for disease research, medical device design and treatment planning. The motivation for quantifying hemodynamic conditions in the human vascular system is presented. A computational method for modeling blood flow, based on the theory of stabilized finite element methods, is detailed and shown to yield exc...

متن کامل

Impact of Tamper Shape on the Efficiency and Vibrations Induced During Dynamic Compaction of Dry Sands by 3D Finite Element Modeling

Dynamic compaction is a soil improvement method which has been widely used for the increase of bearing capacity through stress wave propagation during heavy tamping. The cost and time of project implementation can be effectively curtailed by developing a model that can be used in the design of dynamic compaction operations. The numerical models offered so far are mostly one or two-dimensional, ...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید


عنوان ژورنال:
international journal of marine science and engineering

جلد ۴، شماره ۱، صفحات ۳۷-۴۶

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023