hygroscopic expansion of aesthetic restorative materials: one-year report

نویسندگان

s. emamieh specialist in operative dentistry, private practice

a. ghasemi associate professor, department of operative dentistry, school of dentistry, shahid beheshti univers

h. torabzadeh associate professor, iranian center for endodontics research, shahid beheshti university of medical

چکیده

objective: to measure the long-term linear hygroscopic expansion (lhe) of several materials using bulked and layered techniques. materials and methods: seven materials were used; fuji cap ii, fuji ii lc, photac-fil aplicap, vitremer, dyract, tetric and z100. ten specimens (6×4 mm) were made for each material using layered and bulked techniques (each group comprises five specimens). the specimens were stored in distilled water at 37°c. the length of each specimen was measured immediately after preparation, 24 hours, one week, one month, three months, six months, nine months and one year. this was used to calculate the percentage change in the length of materials. the mean lhe and standard deviation were calculated. repeated measure analysis and paired sample t-test were used. results: the type of material and time had a significant effect on lhe. fuji cap ii and fuji ii lc exhibited no significant changes after one-year and one month, respectively. however, layered specimens of photac-fil aplicap and tetric showed constant expansion until six month, whereas bulked specimens reached the constant length at three months. constant expansion was obtained for layered and bulked specimens of dyract and z100 at six month. layered specimens of vitremer showed no significant differences except between 24 hours and one year measurements. but in bulked specimens, the results at nine months and one year were significantly different from those obtained at three months and before. conclusion: fuji ii showed no significant lhe and resin-modified glass ionomer cements (rmgics) exhibited the highest lhe. dyract maintained an intermediate lhe in comparison with rmgic and composite resin.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Hygroscopic Expansion of Aesthetic Restorative Materials: One-Year Report

OBJECTIVE To measure the long-term linear hygroscopic expansion (LHE) of several materials using bulked and layered techniques. MATERIALS AND METHODS Seven materials were used; Fuji Cap II, Fuji II LC, Photac-Fil Aplicap, Vitremer, Dyract, Tetric and Z100. Ten specimens (6×4 mm) were made for each material using layered and bulked techniques (each group comprises five specimens). The specimen...

متن کامل

Color stability evaluation of aesthetic restorative materials.

Color match is one of the most important characteristics of aesthetic restorative materials. Maintenance of color throughout the functional lifetime of restorations is important for the durability of treatment. This characteristic is not constant among dental materials. The purpose of this research was to assess the color stability of five aesthetic restorative materials when immersed in a coff...

متن کامل

Comparison of shear bond strength of aesthetic restorative materials

AIM The present study was conducted to determine and compare the shear bond strengths of Conventional glass ionomer; Resin-modified glass ionomer; Polyacid-modified composite and Composite Resin, and to assess and determine the mode of failure (adhesive, cohesive, mixed). MATERIALS AND METHODS Occlusal dentin of 40 extracted human teeth were randomly divided into four groups of ten teeth, eac...

متن کامل

Influence of Curing Light Attenuation Caused by Aesthetic Indirect Restorative Materials on Resin Cement Polymerization

OBJECTIVES To verify the effect of interposing different indirect restorative materials on degree of conversion (DC), hardness, and flexural strength of a dual-cure resin cement. METHODS Discs (2 mm-thick, n=5) of four indirect restorative materials were manufactured: a layered glass-ceramic (GC); a heat-pressed lithium disilicate-based glass-ceramic veneered with the layered glass-ceramic (L...

متن کامل

Clinical performance of aesthetic restorative materials in primary teeth according to the FDI criteria.

AIM The purpose of this study is to evaluate the clinical performance of three different restorative materials in primary teeth according to the FDI criteria. MATERIALS AND METHODS Resin-modified glass ionomer cement, compomer and composite resin restorations (n=93) were made in 31 patients. The restorations were clinically evaluated at baseline, 6th, 12th and 18th month with the FDI criteria...

متن کامل

[Hygroscopic expansion of some casting investments].

CREDIT is generally given to Taggart1 for introducing the cast gold inlay to the dental profession. Although he realized that gold shrinks when cooled from molten state to solid state of room temperature, the investment available to him did not supply sufficient compensation. In 1910, Van Horn2 published a paper dealing with a method by which he obtained the compensation by means of wax expansi...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید


عنوان ژورنال:
journal of dentistry, tehran university of medical sciences

جلد ۸، شماره ۱، صفحات ۲۵-۳۲

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023