analysis of internal combustion engines operating parameters with waste heat recovery by two-stage organic rankine cycle

نویسندگان

saeid javan

mojtaba tahani

mohammad javad khodaei

چکیده

in this paper, the amount of wasted heat from different parts of a 12 liter compression ignition engine and their potential for waste heat recovery were investigated. then, two-stage configuration of organic rankine cycle was introduced for simultaneous heat recovery from exhaust gases and coolant. finally, parameters like hybrid generated power, engine thermal efficiency and brake specific fuel consumption were studied in different engine speeds and full engine load. as a result, by using this method, it is possible to produce 35 kw hybrid power, which causes 9.5% reduction in brake specific fuel consumption.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A steam Rankine cycle with two-stage pumping to enhance the waste heat recovery from internal combustion engines

In this research, a high-temperature Rankin cycle (HTRC) with two-stage pumping is presented and investigated. In this cycle, two different pressures and mass flow rates in the HTRC result in two advantages. First, the possibility of direct recovery from the engine block by working fluid of water, which is a low quality waste heat source, is created in a HTRC. Secondly, by doing this, the mean ...

متن کامل

Increasing waste heat recovery from an internal combustion engine by a dual-loop non-organic Rankine Cycle

This research proposes the combination of a dual-loop non-organic Rankine cycle (DNORC) with an internal combustion engine to increase the output power of the recovery system by focusing on the increase in the energy input and system efficiency. In doing so, it investigates the strategy of increasing the mean effective temperature of heat addition in the high-temperature Rankine cycle (HTRC) (t...

متن کامل

A regenerative supercritical-subcritical dual-loop organic Rankine cycle system for energy recovery from the waste heat of internal combustion engines

Organic Rankine cycle (ORC) system is considered as a promising technology for energy recovery from the waste heat rejected by internal combustion (IC) engines. However, such waste heat is normally contained in both coolant and exhaust gases at quite different temperatures. A single ORC system is usually unable to efficiently recover energy from both of these waste heat sources. A dual loop ORC...

متن کامل

Thermo-Economic Performance Analysis of a Regenerative Superheating Organic Rankine Cycle for Waste Heat Recovery

The Organic Rankine Cycle (ORC) is a promising form of technology for recovering low-grade waste heat. In this study, a regenerative ORC system is established to recover the waste flue gas of 160 ◦C. Focusing on thermodynamic and economic performance while simultaneously considering the limitations of volume flow ratio (VFR) and the effect of superheat, working fluid selection and parameter opt...

متن کامل

Waste Heat Recovery of a PEMFC System by Using Organic Rankine Cycle

In this study, two systems are brought forward to recover the waste heat of a proton exchange membrane fuel cell (PEMFC), which are named the organic Rankine cycle (ORC), and heat pump (HP) combined organic Rankine cycle (HPORC). The performances of both systems are simulated on the platform of MATLAB with R123, R245fa, R134a, water, and ethanol being selected as the working fluid, respectively...

متن کامل

Optimal Green Facility Planning - Implementation of Organic Rankine Cycle System for Factory Waste Heat Recovery

As global industry developed rapidly, the energy demand also rises simultaneously. In the production process, there’s a lot of energy consumed in the process. Formally, the energy used in generating the heat in the production process. In the total energy consumption, 40% of the heat was used in process heat, mechanical work, chemical energy and electricity. The remaining 50% were released into ...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید


عنوان ژورنال:
international journal of advanced design and manufacturing technology

جلد ۶، شماره ۴، صفحات ۱-۸

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023