simple photovoltaic device based on multiwall carbon nanotube/silicon heterojunction

نویسندگان
چکیده

multiwall carbon nanotubes (mwcnts) are grown via chemical vapour deposition method directly on a stainless steel substrate. raman spectroscopy and transmission electron microscopy are the techniques chosen to characterize the structure of the synthesized carbon nanotubes: few structural defects are detected. after their removal from the stainless steel substrate, the as-grown mwcnts are then airbrushed on a crystalline n-type silicon substrate to build up a simple photovoltaic device based on the mwcnt/si schottky heterojunction. several devices have been made up by varying the thickness of the mwcnt film. external quantum efficiency (eqe) measurements performed in planar configuration show that si substrate plays the major role in the generation of the electron-hole pairs upon illumination. for this reason, the eqe lineshape closely resembles the behaviour of a p-n junction solar cell. in addition, a sizeable variation of the eqe as a function of the mwcnt film thickness is observed. on-off cycles, performed on the device showing the larger value of eqe (18%), illustrate the genuine photovoltaic effect of our mwcnt/si device.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Simple Photovoltaic Device Based on Multiwall Carbon Nanotube/Silicon Heterojunction

Multiwall carbon nanotubes (MWCNTs) are grown via chemical vapour deposition method directly on a stainless steel substrate. Raman spectroscopy and transmission electron microscopy are the techniques chosen to characterize the structure of the synthesized carbon nanotubes: few structural defects are detected. After their removal from the stainless steel substrate, the as-grown MWCNTs are then a...

متن کامل

Simple Photovoltaic Device Based on Multiwall Carbon Nanotube/Silicon Heterojunction

Multiwall carbon nanotubes (MWCNTs) are grown via chemical vapour deposition method directly on a stainless steel substrate. Raman spectroscopy and transmission electron microscopy are the techniques chosen to characterize the structure of the synthesized carbon nanotubes: few structural defects are detected. After their removal from the stainless steel substrate, the as-grown MWCNTs are then a...

متن کامل

Improved Photovoltaic Properties of Heterojunction Carbon Based Solar Cell

Amorphous carbon (a-C) thin films have been synthesized by microwave (MW) surface wave plasma (SWP) chemical vapor deposition (CVD) on n-type silicon and quartz substrates, aiming at the application of the films for photovoltaic solar cells. Argon, acetylene and trimethylboron were used as a carrier, source and dopant gases. Analytical methods such as X-ray photoelectron spectroscopy (XPS), Hal...

متن کامل

Operation of a reversed pentacene-fullerene discrete heterojunction photovoltaic device

The photoresponse of reversed bilayer organic photovoltaic device based on pentacene and C60 is examined, and the mechanism of photocurrent generation is shown to be different to that in conventional heterojunction devices, with free charge carriers generated at the electrode-organic interfaces rather than the organic heterojunction. This hypothesis is tested with silver nanoclusters incorporat...

متن کامل

Nanoimprinted large area heterojunction pentacene-C60 photovoltaic device

A pentacene-C60 bilayer heterojunction organic photovoltaic device with interpenetrating donor-acceptor interface was fabricated by nanoimprinting the pentacene layer prior to C60 deposition. An amorphous silicon substrate nanostructured using an excimer laser was imprinted onto the pentacene layer at high temperature and pressure, using a nanoimprinting lithography system to form a textured pe...

متن کامل

TCO-Si Based Heterojunction Photovoltaic Devices

It is a common viewpoint that the adscription of the PV research and industry in future has to be the lower cost and higher efficiency. However, those monocrystal as well as multicrystalline silicon wafer require very expensive processing techniques to produce low defect concentrations, and they are made by complicated wet chemical treatment, hightemperature furnace steps, and time-cost metalli...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید


عنوان ژورنال:
international journal of bio-inorganic hybrid nanomaterials

جلد ۱، شماره ۱، صفحات ۱-۶

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023