soil leaching simulation by using hydrus2d software

نویسندگان

ملیحه کرمی

کارشناسی ارشد آبیاری و زهکشی، دانشگاه شهید چمران معصومه فراستی

استادیار گروه مهندسی آب، دانشکده کشاورزی، دانشگاه رازی کرمانشاه رامین ملکی

کارشناسی ارشد آبیاری و زهکشی، دانشکده کشاورزی، دانشگاه رازی کرمانشاه

چکیده

proper management of saline soils needs adequate information about the amount and salt distribution in the root zone. irrigation is one of the factors that control the distribution of salt. this study investigated soil leaching simulation by using hydrus2d software based on the evaporation of soil surface of a land without plant located at shahid chamran university, ahwaz, iran. samples were taken from three distances of 0, 20, and 40 cm from the drip irrigation emitter and 0-20, 20-40, 40-60 and 60-80 cm depths. among the measured depths, the 20 – 40 cm layer was revealed as the best working depths with a salt content of 5.7 mg/cm3, while the depth of 60-80 cm had an average salinity of 10.87 mg/cm3, the highest salt content compared with the other depths.  soil salinity decreased with time and irrigation. at the last irrigation, soil salinity under the dripper reached a salinity of 2.13 mg/cm3 that was 1/15 of the initial amount. salts movement in soil and leaching simulation by hydrus2d software showed that this software simulated salt distribution well.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

CT-Based Brachytherapy Treatment Planning using Monte Carlo Simulation Aided by an Interface Software

Introduction: In brachytherapy, radioactive sources are placed close to the tumor, therefore, small changes in their positions can cause large changes in the dose distribution. This emphasizes the need for computerized treatment planning. The usual method for treatment planning of cervix brachytherapy uses conventional radiographs in the Manchester system. Nowadays, because of their advantages ...

متن کامل

Leaching potential of persistent soil fumigant residues.

Persistent fumigant residues in soil resulting from agricultural pest-control practices may be released into water and leached to groundwater. In this study, the leaching potential of persistent soil fumigant residues was evaluated, and the effect of dissolved organic matter (DOM) and ammonium thiosulfate (ATS) amendment was investigated. A silt loam soil was incubated separately with the fumig...

متن کامل

ct-based brachytherapy treatment planning using monte carlo simulation aided by an interface software

introduction: in brachytherapy, radioactive sources are placed close to the tumor, therefore, small changes in their positions can cause large changes in the dose distribution. this emphasizes the need for computerized treatment planning. the usual method for treatment planning of cervix brachytherapy uses conventional radiographs in the manchester system. nowadays, because of their advantages ...

متن کامل

Software Development for Simulation of Reformer Furnace

In recent years, lots of research has been done on effective usage of natural gas; the first step in these processes is conversion of natural gas to Syngas. Natural gas reforming process by refomer furnace is commonly used for syngas and hydrogen production. In this paper, a windows based software, RIPI-RefSim, is introduced. By using proper heat, mass, kinetic and thermodynamic models as w...

متن کامل

simulation of esfordi phosphate grinding circuit using bmcs software

simulation of grinding circuits has being performed from 30 years ago and is also to be more complete and powerful approach with improvement of mathematical models which simulate various processing units/machines. the modeling and simulation of various mineral processing circuits are presently performed. in order to simulate the present grinding circuits of esfordi phosphate processing plant, a...

متن کامل

Improving Simulation Accuracy of a Downsized Turbocharged SI Engine by Developing a Predictive Combustion Model in 1D Simulation Software

In this paper we aim to develop a predictive combustion model for a turbocharged engine in GT-Power software to better simulate engine characteristics and study its behavior under variety of conditions. Experimental data from combustion was initially being used for modelling combustion in software and these data were used for model calibration and result validation. EF7-TC engine was chosen for...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید


عنوان ژورنال:
پژوهش های خاک

جلد ۲۹، شماره ۱، صفحات ۴۹-۵۷

کلمات کلیدی

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023