experimental investigation and 3d simulation of reaming process on aisi d2 hardened tool steel
نویسندگان
چکیده
0
منابع مشابه
On machining of hardened AISI D2 steel with PCBN tools
This paper describes an experimental investigation on machining of a difficult-to-cut material, AISI D2 steel of hardness 62 HRC with PCBN tools. It was found that the most feasible feeds and speeds fall in the ranges 0.08–0.20 mm/rev and 70–120 m/min, respectively and that most of the tested PCBN tools reached the end of life mainly due to flank wear. The highest acceptable values of tool life...
متن کاملPrediction of Tool Life in End Milling of Hardened Steel AISI D2
Most published research works on the development of tool life model in machining of hardened steels have been mainly concerned with the turning process, whilst the milling process has received little attention due to the complexity of the process. Thus, the aim of present study is to develope a tool life model in end milling of hardened steel AISI D2 using PVD TiAlN coated carbide cutting tool....
متن کاملApplications of Impedance Plane and Magnetic Differential Permeability in Microstructural Characterization of AISI D2 Tool Steel
Two nondestructive electromagnetic/magnetic techniques including hysteresis loop and eddy current methodologies have been used to characterize microstructural changes of AISI D2 cold work tool steel as a result of quench and tempering treatments. To measure the fraction retained austenite in quenched microstructure, six specimens were austenitized in the range of 1000-1130 °C. Samples austenit...
متن کاملModeling and Analysis of Process Parameters on Surface Roughness in EDM of AISI D2 Tool Steel by RSM Approach
In this research, Response Surface Methodology (RSM) is used to investigate the effect of four controllable input variables namely: discharge current, pulse duration, pulse off time and applied voltage Surface Roughness (SR) of on Electrical Discharge Machined surface. To study the proposed second-order polynomial model for SR, a Central Composite Design (CCD) is used to estimation the model co...
متن کاملFinite Element Simulation and Experiment of Chip Formation Process during High Speed Machining of AISI 1045 Hardened Steel
As an advanced manufacturing technology which has been developed rapidly in recent years, high speed machining is widely applied in many industries. The chip formation during high speed machining is a complicated material deformation and removing process. In research area of high speed machining, the prediction of chip morphology is a hot and difficult topic. A finite element method based on th...
متن کاملScanning Based Induction Heating for AISI 4340 Steel Spline Shafts-3D Simulation and Experimental Validation
This paper presents an investigation of non-stationary induction heating process applied to AISI 4340 steel spline shafts based on 3D simulation and experimental validation. The study is based on the knowledge, concerning the form of correlations between various induction heating parameters and the final hardness profile, developed in the case of stationary induction heating. The proposed appro...
متن کاملمنابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
مهندسی مکانیک مدرسجلد ۱۵، شماره ویژه نامه -۱۳، صفحات ۲۹-۳۳
میزبانی شده توسط پلتفرم ابری doprax.com
copyright © 2015-2023