proton beam dosimetry by cr-39 track-etched detector

نویسندگان

m. ghergherehchi department of nuclear engineering and physics, amirkabir university of technology, tehran, iran

h. afarideh department of nuclear engineering and physics, amirkabir university of technology, tehran, iran

m. ghanadi nuclear science and technology research institute, tehran, iran

a. mohammadzadeh nuclear science and technology research institute, tehran, iran

چکیده

background: high and intermediate energy protons are not able to form a track in a solid state nuclear track detector (ssntd) directly. however, such tracks can be formed through secondary particles created during primary radiation nuclear reactions in a ssntd. materials and methods: the protons with primary energies of 9.6 and 30 mev available at the cyclotron accelerator with corresponding low lets of 5.87 and 2.40 kev/μm were taken into consideration. the nuclear tracks etch rate ratio v in cr-39 were measured and transformed into let spectra for the absorbed and equivalent dose measurements. results: the optimum etching condition of 6 n naoh solutions at 65 to 70 ºc over a 6-hour period for the cr-39 were found initially. the corresponding bulk etching rate reached a steady rate of about 0.62 to 1.3 um/h after nine hours for an optimum etching condition. although the let was low, but the energy range seemed sufficient enough to create secondary particles with much higher let through the nuclear reactions in cr-39. the relative absorbed dose contribution of the created secondary particles to the primary particles for the 9.6 and 30 mev protons in cr-39 at 1 gy entrance dose were 7.5 and 29.6%, respectively. conclusion: the contribution of the secondary particle increased relatively with the proton energy decrease. this phenomenon could modify the characteristics of the energy transfer process due to secondary particles when such particles are used for radiobiological studies and/or for radiotherapy. iran. j. radiat. res., 2008 6 (3): 113-120

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Proton beam dosimetry by CR-39 track-etched detector

Background: High and intermediate energy protons are not able to form a track in a solid state nuclear track detector (SSNTD) directly. However, such tracks can be formed through secondary particles created during primary radiation nuclear reactions in a SSNTD. Materials and Methods: The protons with primary energies of 9.6 and 30 MeV available at the cyclotron accelerator with corresponding lo...

متن کامل

A parameterization of nuclear track profiles in CR-39 detector

In this work, the empirical parameterization describing the alpha particles’ track depth in CR-39 detectors is extended to describe longitudinal track profiles against etching time for protons and alpha particles. MATLAB based software is developed for this purpose. The software calculates and plots the depth, diameter, range, residual range, saturation time, and etch rate versus etching time. ...

متن کامل

Neutron detection by a CR-39 detector and analysis of proton tracks etched in the same and opposite directions.

A program code to simulate neutron interactions with a CR-39 detector and calculate parameters describing the induced etched proton tracks in the CR-39 material was previously developed(( 1)). This code was used to understand the mechanisms involved during interactions with neutrons in the CR-39 material and the influence of the etching process, enabling an improvement in the efficiency of the ...

متن کامل

Computer program TRACK_VISION for simulating optical appearance of etched tracks in CR-39 nuclear track detectors

A computer program called TRACK_VISION for determining the optical appearances of tracks in nuclear track materials resulted from lightion irradiation and subsequent chemical etching was described. A previously published software, TRACK_TEST, was the starting point for the present software TRACK_VISION, which contained TRACK_TEST as its subset. The programming steps were outlined. Descriptions ...

متن کامل

Bulk and track etch properties of CR-39 SSNTD etched in NaOH/ethanol

Recently, Matiullah et al. described the use of NaOH/ethanol as an etchant for the CR-39 detector, and have determined the corresponding bulk and track etch properties from the track diameter method. In the present work, the bulk and track etch properties of CR39 in NaOH/ethanol were derived from direct measurements. The bulk etch rate has been found to increase with the molarity of NaOH/ ethan...

متن کامل

Uranium concentration in blood samples of Southern Iraqi leukemia patients using CR-39 track detector

The simple and effective technique of fission track etch has been applied to determine trace concentration of uranium in human blood samples taken from two groups of male and female participants: leukemia patients and healthy subjects group. The blood samples of leukemia patients and healthy subjects were collected from three key southern governorates namely, Basrah, Muthanna and Dhi-Qar. These...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید


عنوان ژورنال:
iranian journal of radiation research

جلد ۶، شماره ۳، صفحات ۱۱۳-۱۲۰

کلمات کلیدی
[ ' l e t ' , ' i n t e r m e d i a t e e n e r g y p r o t o n s ' , ' t r a c k e t c h d e t e c t o r s ' , ' c r ' , 3 9 , ' p r o t o n r a d i o t h e r a p y . ' ]

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023