numerical simulation of air-water flow in bottom outlet

نویسندگان

a. shamsai

r. soleymanzadeh

چکیده

flow regime in dam's bottom outlet is divided in pressurized flow and free surface flow by the gate located for discharge control. down stream tunnel involves high velocity multi component air –water flow studied by mathematical model. in this research work, we used finite volume mixture two phase flow model. because of high reynolds number, standard two equations k-e turbulence model was used. model was verified by backward-facing step flow and results have been compared with experiments founded by durst and schmitt. air demand ratio has been determined as function of froude number at contracted section. flow patterns have been compared at two categories of slug & stratified flows, air mean concentration profile has been obtained at down stream tunnel. comparison of flow pattern at two case with and without of aeration was investigated. pressure drop behind of the gate and formation of vortex flow after the gate section have been discussed. measurement of flow discharge and determination of contraction coefficient of the gate was outlined.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Experimental and Numerical Investigation of Bottom Outlet Hydraulic Model

Using experimental models along with conducting numerical analysis have been widely used in performance recognition and optimization of hydraulic equipments. Numerical modeling has lower cost rather than experimental one; however practical tests are commonly used because of the hydraulic structure importance especially in dams. Meanwhile numerical methods could be used for future designs throug...

متن کامل

Numerical Simulation of Air-Water Bubbly Flow in Axial Flow Pump Impeller

In this paper, the lift-law method was applied to design the axial flow pump. Based on Reynolds time-averaged N-S equations and standard k turbulent model, three-dimensional air-water bubbly flow in an axial flow pump impeller was simulated. Under the condition of bubble void fraction of 5%, pressure and void fraction distributions were respectively obtained, movement of bubbles in the impeller...

متن کامل

development of a 2-d numerical model for simulation of air distribution in high speed air water flow

in the present study a quasi 2-d numerical model is developed for calculating air concentration distribution in rapid flows. the model solves air continuity equation (convection diffusion equation) in the whole flow domain. this solution is then coupled with calculations of the free surface in which air content in the flow is also considered. to verify the model, its results are compared with a...

متن کامل

Numerical simulation of the annual circulation of water flow in the Persian Gulf

The Persian Gulf is an important region in the world regarding energy supply, transportation, shipping, and military missions. Therefore, studying the annual circulation of water current in the Persian Gulf is very important for marine experts. In the present study, the simulation of current circulation in the Persian Gulf has been studied using ROMS numerical model and field observations. The ...

متن کامل

Numerical Simulation of Flow Field in a Elliptic Bottom Stirred Tank with Bottom Baffles

When the crisscross baffles and logarithmic spiral baffles are placed on the bottom of the stirred tank with elliptic bottom, using CFD software FLUENT simulates the velocity field of the stirred tank with elliptic bottom and bottom baffles. Compare the velocity field of stirred tank with bottom crisscross baffle to the velocity field of stirred tank without bottom baffle and analysis the flow ...

متن کامل

Numerical simulation of turbulent flow around the dtmb4119 propeller in open water conditions

In this study, ANSYS-FLUENT packages are employed to simulate the turbulent flow around DTMB4119 propeller in open water conditions. In order to form a mesh, the multiple reference frame (MRF) methodology is used. The results are compared with the experimental results and a good conformity is obtained, which endorses numerical simulation. Furthermore, the  turbulence model is used, which is sup...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید


عنوان ژورنال:
international journal of civil engineering

جلد ۴، شماره ۱، صفحات ۱۴-۳۳

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023