Ytterbium-doped glass waveguide laser fabricated by ion exchange
نویسندگان
چکیده
منابع مشابه
Ytterbium-Doped Glass Waveguide Laser Fabricated by Ion Exchange
A ytterbium-doped, glass, channel waveguide laser, fabricated by ion exchange, is reported. The 2.2-cm long device, using broad-band 4% output couplers, lased in the vicinity from 1020 to 1030 nm when pumped by a Ti : sapphire laser operating at 910 nm. A lasing threshold of 50 mW (launched pump) and a slope efficiency of 5% were measured. Device parameters, including fluorescence lifetimes, em...
متن کاملPlanar Er:Yb glass ion exchanged waveguide laser - Electronics Letters
Introduction: Er3+:Yb3+ codoping has become an effective method for producing short, efficient lasers and amplifiers in the long haul telecommunications wavelength range. Ytterbium codoping increases the pump absorption near 980nm and efficient energy transfer between the Yb’’ and the Er3+ ions enables the operation of centimetre long lasers with low Er” concentrations. This mechanism was first...
متن کاملYtterbium-Phosphate Glass for Microstructured Fiber Laser
In the paper, we report on the development of a synthesis and melting method of phosphate glasses designed for active microstructured fiber manufacturing. Non-doped glass synthesized in a P₂O₅-Al₂O₃-BaO-ZnO-MgO-Na₂O oxide system served as the matrix material; meanwhile, the glass was doped with 6 mol% (18 wt%) of Yb₂O₃, as fiber core. The glasses were well-fitted in relation to optical (refract...
متن کاملWaveguide lasers in ytterbium-doped tantalum pentoxide on silicon.
A waveguide laser in an ytterbium-doped tantalum pentoxide film is reported. The waveguide is formed of a rib of sputtered tantalum pentoxide on top of oxidized silicon with an over-cladding of silica. Emission at a wavelength of 1025 nm was achieved with an absorbed pump power threshold and slope efficiency of ≈29 mW and 27%, respectively, for a cavity formed by a high reflector mirror and an...
متن کاملOptical waveguide filter fabricated by excimer laser irradiation
Ge-SiO2 thin films highly photosensitive to excimer laser light were deposited by plasma enhanced chemical vapor deposition. In this paper, the following two studies are reported: (1) Direct writing of the channel waveguide was successfully confirmed only by irradiation with excimer laser through a Cr mask pattern, which was previously coated on the slab waveguide by sputtering method. Bragg gr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Lightwave Technology
سال: 1999
ISSN: 0733-8724
DOI: 10.1109/50.788565