منابع مشابه
γ-Si3N4 at Elevated Temperatures and Pressures
c © 2008 by John von Neumann Institute for Computing Permission to make digital or hard copies of portions of this work for personal or classroom use is granted provided that the copies are not made or distributed for profit or commercial advantage and that copies bear this notice and the full citation on the first page. To copy otherwise requires prior specific permission by the publisher ment...
متن کاملTHE DEFORMATION BEHAVIOR OF AZ31 MAGNESIUM ALLOY AT ELEVATED TEMPERATURES
AZ31 magnesium alloy is considered as a promising alloy in various applications and industries. Furthermore, to design a proper hot working process (rolling, forging and extrusion), the assessment of hot working behaviour of the alloy is necessary. Accordingly, the hot deformation behaviour of AZ31 alloy was studied through hot compression testing method This was carried out in a wide range of ...
متن کاملCavity optomechanics with Si3N4 membranes at cryogenic temperatures
We describe a cryogenic cavity-optomechanical system that combines Si3N4 membranes with a mechanically rigid Fabry–Perot cavity. The extremely high products of quality factor and frequency of the membranes allow us to cool a MHz mechanical mode to a phonon occupation of n̄ < 10, starting at a bath temperature of 5K. We show that even at cold temperatures thermally occupied mechanical modes of th...
متن کاملHydrodynamics of a Gas-Solid Fluidized Bed at Elevated Temperatures Using the Radioactive Particle Tracking Technique
Effect of temperature on hydrodynamics of bubbling gas-solid fluidized beds was investigated. Experiments were carried out in the range of 25-600 ºC and different superficial gas velocities in the range of 0.17-0.78 m/s with sand particles. Time-position trajectory of particles was obtained by radioactive particle tracking technique. These data were used for determination of mean velocitie...
متن کاملMicrostructural Evolution of Roll Bonded Al-Clad Stainless Steel Sheets at Elevated Temperatures
The cold roll bonding of Al on AISI 304L stainless steel was carried out to fabricate the Al/304L/Al clad sheet composites. The maximum bond strength of 20 N/mm was acquired just by 38% reduction, for which the tearing of the aluminum sheet occurred during the peeling test. The microstructural evolution during subsequent postannealing heat treatment was systematically studied based on the impur...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Association, Japan
سال: 1986
ISSN: 1884-2127,0009-0255
DOI: 10.2109/jcersj1950.94.1089_536