X-Ray Stress Measurement of WC-Co Alloys.
نویسندگان
چکیده
منابع مشابه
TEM INVESTIGATIONS OF WC-Co ALLOYS AFTER CREEP EXPERIMENTS
Carbide tungsten cobalt alloys were deformed in compression or in three point bending in a temperature range 1000-1350°C and in a stress domain 30-1000MPa. In these conditions, the stress exponent n of WC-CO alloys is a function of only the cobalt volurnic ratio and tends tow rds n = 1 for pure B carbide. The apparent activation energy is 550 kj mole. T.E.M. investigations on pure carbide defor...
متن کاملResidual Stress in Ground WC-Co Coatings
High velocity oxygen fuel (HVOF) spray technique is one of the leading technologies that have been proposed as an alternative to the replacement of electrolytic hard chromium plating in a number of engineering applications. In this study, WC-Co powder was coated on AISI1045 steel using high velocity oxy fuel (HVOF) method. The sinψ method was used to evaluate the through thickness residual stre...
متن کاملNanostructured thermoelectric skutterudite Co(1-x)Ni(x)Sb3 alloys.
Nanostructured Ni-doped skutterudites Co(1-x)Ni(x)Sb3 (with x ranging from 0.01 to 0.09) were prepared by ball milling and direct-current induced hot press. It was found that the thermal conductivity was reduced due to strong electron-phonon scattering from Ni-doping as well as phonon scattering from the increased grain boundary of the nanostructures. A maximum dimensionless figure-of-merit of ...
متن کاملElliptical X-ray Spot Measurement
The so-called roll bar measurement uses a heavy metal material, optically thick to x-rays, to form a shadow of the x-ray origination spot. This spot is where an energetic electron beam interacts with a high Z target. The material (the “roll bar”) is slightly curved to avoid alignment problems. The roll bar is constructed and positioned so that the x-rays are shadowed in the horizontal and verti...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 1993
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.42.96