X-ray stress measurement of silicon carbide by gaussian curve method.
نویسندگان
چکیده
منابع مشابه
Determination of the phonon dispersion of zinc blende „3C... silicon carbide by inelastic x-ray scattering
We present an experimental and theoretical investigation of the phonon dispersion relations in zinc blende (3C) SiC. The experimental data were obtained for the entire Brillouin zone by inelastic x-ray scattering ~IXS! using a synchrotron radiation source. Eigenvector analysis is performed with the aid of state-of-the-art linear response first principles calculations based on density functional...
متن کاملX-ray Stress Measurement for Ni-Al System Intermetallic Compound Prepared by SHS- method
An X-ray diffraction technique was used to measure the residual stress in the surface of a specimen containing a coating of a NijAl intermetallic compound produced bythe SHS (Self-propagation High temperature Synthesis) method. The Ni3Al was using the coating material for spherical carbon cast iron substrate and austenite stainless steel substrate. Differences between the coefftcient of thermal...
متن کاملPorosity Measurement Method by X-ray Computed Tomography
Therefore, the new method, called the grey level method, which reflects the phenomenon of image processing and computation of ration between the volume of voids and the total volume of the entire sample, was considered and improved in term of image noise and artifacts. The volumes of 2D CT image as a surface are achieved by means of integrating the surface with operations relating to image hist...
متن کاملSilicon Carbide Grains of Type X and Supernova Nucleosynthesis
Silicon carbide grains of type X constitute ~1% of all presolar SiC grains found in primitive meteorites. These grains have N and Si excesses, mostly light C, high inferred Al/Al ratios, and evidence (from Ca and Ti excesses) for the initial presence of the short-lived radioisotopes Ti and V. These isotopic signatures clearly indicate an origin in the ejecta of Type II supernovae (SNe) and mate...
متن کاملMeasurement of Figure of Merit for a Single β-Silicon Carbide Nanowire by the Four-Point Three-ω Method
The thermoelectric figure of merit (ZT) of a single β-Silicon Carbide (SiC) nanowire (NW) was measured using the four-point three-omega (3-ω) method for the first time. The electrical conductivity (σ), thermal conductivity (κ), and Seebeck coefficient (S) were measured on the same measurement platform consisting of four point probe. To this end, we developed a novel technique in which focused i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 1988
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.37.1463