Work-hardening Process of Scratch-deformed Surface Layer of Cu Single Crystals
نویسندگان
چکیده
منابع مشابه
Strain hardening behavior of aluminum alloyed Hadfield steel single crystals
Very high strain hardening coefficients (=G/23) are observed for aluminum-alloyed face-centered cubic Hadfield steel single crystals under tensile loading. Alloying with aluminum suppressed deformation twinning in two of the three crystallographic orientations studied, and transmission electron microscopy results revealed the existence of dense dislocation walls (sheets) along crystallographic ...
متن کاملOn the Optimum Die Shape in Rod Drawing Process Considering Work-Hardening Effect of Material
The assessment of the influence of the work-hardening of material on the optimum die profile and drawing force in rod drawing process is the main objective of the present paper. The upper bound solution, based on the assumption of perfect plasticity, has been extended to consider the work-hardening of the material during the rod drawing process through curved dies. Analytical results of drawin...
متن کاملThe recrystallization of copper single crystals deformed at 4.2 K
The deformation of copper single crystals at 4.2 K occurs by a sequence of slip, twinning and slip in the twinned structure. Subsequent annealing of the deformed structures obtained at various points at this sequence of deformation permits the detailed nature of the deformed and recrystallized states to be related in a unique fashion. Material recrystallized from structures obtained prior to th...
متن کاملSkin layer of BiFeO(3) single crystals.
A surface layer ("skin") different from the bulk was found in single crystals of BiFeO(3). Impedance analysis and grazing incidence x-ray diffraction reveal a phase transition at T(*)∼275±5 °C that is confined within the surface of BiFeO(3). X-ray photoelectron spectroscopy and refraction-corrected x-ray diffraction as a function of incidence angle and photon wavelength indicate a reduced elect...
متن کاملNumerical and Experimental Investigation of Deep Drawing Process in Square Section of Single-Layer and Two-Layer Sheet
Deep drawing of two-layer sheet is a suitable way to achieve product with a desired shape and desired properties in sheet metal forming technology. Control of deep drawing parameter such as thinning is the most important challenge in this process. The most difficult part of this challenge is differences in material properties and geometry of each layer. In this paper, numerical approach has bee...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Precision Engineering
سال: 1979
ISSN: 0374-3543
DOI: 10.2493/jjspe1933.45.455