Work Hardening Behavior of IF and Low Carbon Steel Sheets under Biaxial Tension
نویسندگان
چکیده
منابع مشابه
Recrystallization Behavior of Deep Drawing Low Carbon Steel Sheets Produced by Mobarakeh Steel Plant
In the present work the recrystallization behavior of deep drawing grade Al-killed low carbon steel sheets produced by Mobarakeh Steel Plant (MSP) has been studied. Salt bath isothermal annealing has b...
متن کاملWork-Hardening and Deformation Mechanism of Cold Rolled Low Carbon Steel
The study reports the mechanical property and microstructure of cold rolled low carbon steel and its work-hardening behavior in the deformation process. The tensile test in room temperature of low carbon steel was implemented for the different cold rolling deformation, the stress-strain curve was draught according to the relationship between strength and deformation and fitted for the polynomia...
متن کاملrecrystallization behavior of deep drawing low carbon steel sheets produced by mobarakeh steel plant
in the present work the recrystallization behavior of deep drawing grade al-killed low carbon steel sheets produced by mobarakeh steel plant (msp) has been studied. salt bath isothermal annealing has been applied to cold rolled samples and the resulted microstrucrures have been compared with the microstructure obtained from the box annealing process in msp. it is found that at 635 and 700ºc the...
متن کاملImprovement of Mechanical Properties and Work-Hardening Behavior of Intercritically Annealed Dual Phase Steel
The effect of the initial microstructure and intercritical annealing on mechanical properties and work-hardening response of a high-formability low carbon steel were studied. The work-hardening analysis was based on the modified Crussard–Jaoul method. The ferritic-pearlitic sheets showed low strength and high total elongation with the appearance of the yield point phenomenon. The occurrence of ...
متن کاملAn Experimental and Numerical Study of Forming Limit Diagram of Low Carbon Steel Sheets
The forming limit diagram (FLD) is probably the most common representation of sheet metal formability and can be defined as the locus of the principal planar strains where failure is most likely to occur. Low carbon steel sheets have many applications in industries, especially in automotive parts, therefore it is necessary to study the formability of these steel sheets. In this paper, FLDs, wer...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 2004
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.90.12_1016