White layer changes in cBN tools when turning hardened steel
نویسندگان
چکیده
منابع مشابه
Machinability of Hard Martensitic Stainless Steel and Hard Alloy Steel by CBN and PCBN Tools by Turning Process
Hard turning of martensitic stainless steel is gaining importance in all manufacturing sectors like automobile and aerospace industries. Machinability of materials depends on surface roughness, tool wear, cutting forces, specific cutting pressure and work material hardness. In this research hard martensitic stainless steel AISI 440 C and SCM 440 alloy steel was used as work materials. CBN and P...
متن کاملPrediction of flank wear by using back propagation neural network modeling when cutting hardened H-13 steel with chamfered and honed CBN tools
Productivity and quality in the finish turning of hardened steels can be improved by utilizing predicted performance of the cutting tools. This paper combines predictive machining approach with neural network modeling of tool flank wear in order to estimate performance of chamfered and honed Cubic Boron Nitride (CBN) tools for a variety of cutting conditions. Experimental work has been performe...
متن کاملOn machining of hardened AISI D2 steel with PCBN tools
This paper describes an experimental investigation on machining of a difficult-to-cut material, AISI D2 steel of hardness 62 HRC with PCBN tools. It was found that the most feasible feeds and speeds fall in the ranges 0.08–0.20 mm/rev and 70–120 m/min, respectively and that most of the tested PCBN tools reached the end of life mainly due to flank wear. The highest acceptable values of tool life...
متن کاملMicrohardness Changes Gradient of the Duplex Stainless Steel (dss) Surface Layer after Dry Turning
G. Krolczyk, Opole University of Technology, Faculty of Production Engineering and Logistics, Opole, Poland; P. Nieslony, Opole University of Technology, Department of Manufacturing Engineering and Production Automation; S. Legutko, Poznan University of Technology, Institute of Mechanical Technology, Poznan, Poland; I. Samardzic, J.J. Strossmayer University of Osijek, Mechanical Engineering Fac...
متن کاملExperimental Study & Modeling of Surface Roughness in Turning of Hardened AISI 4340 Steel Using Coated Carbide Inserted
Turning of hardened steels using a single point cutting tool has replaced the cylindrical grinding now as it offers attractive benefits in terms of lower equipment costs, shorter set up time, fewer process setups, higher material removal rate, better surface quality and elimination of cutting fluids compared to cylindrical grinding. In order to obtain desired surface quality by machining, pr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tehnika
سال: 2015
ISSN: 0040-2176
DOI: 10.5937/tehnika1504631a