Wetting properties of titanium oxides, oxynitrides and nitrides obtained by DC and pulsed magnetron sputtering and cathodic arc evaporation
نویسندگان
چکیده
منابع مشابه
CrNx Films Prepared by DC Magnetron Sputtering and High-Power Pulsed Magnetron Sputtering: A Comparative Study
CrNx (0 ≤ x ≤ 0.91) films synthesized using highpower pulsed magnetron sputtering, also known as high-power impulse magnetron sputtering (HiPIMS), have been compared with those made by conventional direct-current (dc) magnetron sputtering (DCMS) operated at the same average power. The HiPIMS deposition rate relative to the DCMS rate was found to decrease linearly with increasing emission streng...
متن کاملThe reactive sputtering of oxides and nitrides
Abstrad: Recent developments in the techniques used to produce surface layers of oxides and nitrides by reactive sputtering are considered. These techniques have to give films which can be produced onto large-area, low-temperature substrate materials, such as glass and polymer. It is shown that this has led to the adoption of ion-assisted processes. In particular the use of plasmas leaked from ...
متن کاملThe Effect of Substrate on Structural and Electrical Properties of Cu3N Thin Film by DC Reactive Magnetron Sputtering
The aim of this paper is to study the effect of substrate on the Cu3N thin films. At first Cu3N thin films are prepared using DC magnetron sputtering system. Then structural properties, surface roughness, and electrical resistance are studied using X-ray diffraction (XRD), the atomic force microscope (AFM) and four-point probe techniques respectively. Finally, the results are investigated and c...
متن کاملPulsed DC Power Supplies for Dual Magnetron Sputtering
Key features of this waveform are the voltage boost period following each polarity transition and fast current rise time due to that boost. Ideally, the boost voltage would be adjustable. It is expected that adjusting the boost voltage will enable some tuning of the film properties, since it will effectively allow tuning of ion energy within the process. Additionally, adjustable duty, the ratio...
متن کاملCOMPARISON OF THE CrN , TiN AND (Ti, Cr)N PVD COATINGS DEPOSITED BY CATHODIC ARC EVAPORATION
In the present study, CrN, TiN and (Ti, Cr)N coatings were deposited on D6 tool steel substrates. Physical and mechanical properties of coatings such as microstructure, thickness, phase composition, and hardness were evaluated. Phase compositions were studies by X-ray diffraction method. Mechanical properties were determined by nano-indentation technique. The friction and wear behaviour of the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Science-Poland
سال: 2019
ISSN: 2083-134X
DOI: 10.2478/msp-2019-0031