Wet chemical deposition of transparent conducting coatings in glass tubes
نویسندگان
چکیده
منابع مشابه
Low Temperature Gas Sensing Coatings Made Through Wet Chemical Deposition of Niobium Doped Titanium Oxide Colloid
Niobium doped titanium oxide (TiO2) colloid was synthesized to fabricate a hydrogen gas sensor layer on oxidized silicon wafer substrate. The layers were obtained using spin coating technique and then heated in air at 500 ̊C for 30 min. The doping of TiO2 led to a significant enhancement of the sensitivity of the layer especially at low operating temperature. The effect of doping was found effec...
متن کاملChemical Vapor Deposition of Antimicrobial Polymer Coatings
There is large and growing interest in making a wide variety of materials and surfaces antimicrobial. Initiated chemical vapor deposition (iCVD), a solventless lowtemperature process, is used to form thin films of polymers on fragile substrates. To improve research efficiency, a new combinatorial iCVD system was fabricated and used to efficiently determine the deposition kinetics for two new po...
متن کاملChamberless plasma deposition of glass coatings on plastic
A chamberless, remote plasma deposition process has been used to coat silicon and plastic substrates with glass at ambient conditions. The films were deposited by introducing an organosilane precursor into the afterglow of an atmospheric plasma fed with helium and 2 vol% oxygen. The precursors examined were hexamethyldisilazane, hexamethyldisiloxane, tetramethyldisiloxane, tetramethylcyclotetra...
متن کاملDetermination of Optical Properties in Germanium Carbon Coatings Deposited by Plasma Enhanced Chemical Vapor Deposition
In this research, Germanium-carbon coatings were deposited on ZnS substrates by plasma enhanced chemical vapor deposition (PECVD) using GeH4 and CH4 precursors. Optical parameters of the Ge1-xCx coating such as refractive index, Absorption coefficient, extinction coefficient and band gap were measured by the Swanepoel method based on the transmittance spectrum. The results showed that the refra...
متن کاملCorrelation between Chemical Glass Components and the Glass Sticking on Sputtered PtIr Physical Vapour Deposition Coatings for Precision Blank Moulding
The increasing demand on high quality optical systems with complex geometries, low tolerances and a low installation space necessitates new replicative production systems for complex optical glass elements. The technology precision blank moulding shows promising properties to comply with these demands on an industrial bulk production. Due to the required high surface quality and low surface rou...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Thin Solid Films
سال: 2003
ISSN: 0040-6090
DOI: 10.1016/s0040-6090(03)00941-6