Wet chemical deposition of ATO and ITO coatings using crystalline nanoparticles redispersable in solutions
نویسندگان
چکیده
منابع مشابه
Growth of coatings on nanoparticles by photoinduced chemical vapor deposition
Photoinduced chemical vapor deposition was used to grow organic coatings on NaCl nanoparticles. Aerosolized nanoparticles were mixed with a vapor-phase coating reactant and introduced into a room-temperature, atmospheric-pressure cell, where the mixture was exposed to 172-nm radiation from a Xe2* excimer lamp. Several coating reactants were investigated; the most successful was methyl methacryl...
متن کاملWet chemical synthesis and physical characterization of doped CeO2 nanoparticles
Solid electrolytes based on doped cerium oxide, Ce(M)O2-δ (M = rare-earth cations), are of considerable interest for potential use in low temperature solid oxide fuel cells (LTSOFCs) due to its higher ionic conductivity than YSZ based solid electrolyte. In this research work, crystalline, pure Ce1-xMxO2-δ (where M = Gd or Sm, x = 0.10 or 0.20) based nanoparticles were prepared by chemical prec...
متن کاملLow Temperature Gas Sensing Coatings Made Through Wet Chemical Deposition of Niobium Doped Titanium Oxide Colloid
Niobium doped titanium oxide (TiO2) colloid was synthesized to fabricate a hydrogen gas sensor layer on oxidized silicon wafer substrate. The layers were obtained using spin coating technique and then heated in air at 500 ̊C for 30 min. The doping of TiO2 led to a significant enhancement of the sensitivity of the layer especially at low operating temperature. The effect of doping was found effec...
متن کاملSuper-Hydrophobic and Oloephobic Crystalline Coatings by Initiated Chemical Vapor Deposition
Preferred crystallographic orientation (texture) in thin films frequently has a strong effect on the properties of the materials and it is important for stable surface properties. Organized molecular films of poly-perfluorodecylacrylate p(PFDA) were deposited by initiated Chemical Vapor Deposition (iCVD). The high tendency of p(PFDA) to crystallize has been fully retained in the polymers prepar...
متن کاملChemical Vapor Deposition of Antimicrobial Polymer Coatings
There is large and growing interest in making a wide variety of materials and surfaces antimicrobial. Initiated chemical vapor deposition (iCVD), a solventless lowtemperature process, is used to form thin films of polymers on fragile substrates. To improve research efficiency, a new combinatorial iCVD system was fabricated and used to efficiently determine the deposition kinetics for two new po...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Thin Solid Films
سال: 1999
ISSN: 0040-6090
DOI: 10.1016/s0040-6090(99)00209-6