Welding Phenomena and Process Control in the Flash Welding of Steel Sheets(Report 1). Weld Defects and Evaluation of Weld Quality.
نویسندگان
چکیده
منابع مشابه
Effect of Mig Welding Input Process Parameters on Weld Bead Geometry on Hsla Steel
The various welding parameters such as welding speed, voltage and gas flow rate were varied on HSLA steel and the effects of these parameters on weld bead geometry such as penetration, width & height have been studied. Mathematical equations have been developed using factorial technique. And the result of various effects are shown in tables. (Numerical Values). INTRODUCTION Wide variety of stee...
متن کاملWeld Quality Prediction of Mild Steel Pipe Joint during Shielded Metal Arc Welding through fuzzy Logic
The present paper describes fuzzy logic simulation of shielded metal arc welding (SMAW) process to predict the Quality of weld joint. It describe the quality of weld joint & effect of welding current, voltage and welding speed on tensile strength of shielded metal arc pipe welded mild steel joints. An ERW Mild steel pipe I S 1239 of 6 mm thickness and 150 mm diameter were used as the base mater...
متن کاملWeld Magnification Factor Approach in Cruciform Joints Considering Post Welding Cooling Medium and Weld Size
The objective of this research is to develop an experimental-theoretical analysis about the influence of the cooling medium and the geometry of the welding bead profile in fatigue life and the associated parameters with structural integrity of welded joints. A welded joint with cruciform geometry is considered using SMAW (Shielded Metal ArcWelding), plates in structural steel ASTM A36 HR of 8 m...
متن کاملAnalysis of Resistance Spot Welding Process Parameters Effect on the Weld Quality of Three-steel Sheets Used in Automotive Industry: Experimental and Finite Element Simulation
In the present research, the effects of spot-welding process parameters on the nugget diameter and electrode penetration depth of spot-welded joints were investigated. To achieve this, a spot-welded joint of three-thin sheet low carbon steels (same thicknesses of 0.8 mm) was simulated as an electerical-thermal-mechanical coupling of 3D finite element model. After validating the finite element s...
متن کاملthe choice of automatic welding process and technology by using weld-exp. software
during last ten years, change of consumption pattern, variety and modernity of consumers, variety of producers and competitors, changes and vacillation rates, cause developing and decreasing the amounts of produce expenses by using hardware and software progressing, which are so important. in this respect, one of the possible solutions to increase the quality and enjoy the use of software possi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY
سال: 1995
ISSN: 0288-4771
DOI: 10.2207/qjjws.13.365