منابع مشابه
Investigation of structural changes in resistance spot welding of advanced high strength steel DP590
The structural and hardness developed in advanced high-strength steel DP590 have been investigated with the help of optical microscopy and scanning electron microscopy on resistance spot welded specimens. The hardness diagram of the weld sections was prepared by microhardness test and the temperature peak and heat distribution were simulated by menas of the Abaqus software. The results show tha...
متن کاملInvestigation of structural changes in resistance spot welding of advanced high strength steel DP590
The structural and hardness developed in advanced high-strength steel DP590 have been investigated with the help of optical microscopy and scanning electron microscopy on resistance spot welded specimens. The hardness diagram of the weld sections was prepared by microhardness test and the temperature peak and heat distribution were simulated by menas of the Abaqus software. The results show tha...
متن کاملReal-time monitoring of laser welding of galvanized high strength steel in lap joint configuration
Two different cases regarding the zinc coating at the lap joint faying surface are selected for studying the influence of zinc vapor on the keyhole dynamics of the weld pool and the final welding quality. One case has the zinc coating fully removed at the faying surface; while the other case retains the zinc coating on the faying surface. It is found that removal of the zinc coating at the fayi...
متن کاملResearch on Cold Crack Sensitivity of High- Strength Wear-resistant Steel Nm360 after Welding
Article history: Received: 21.04.2014. Received in revised form: 02.07.2014. Accepted: 14.07.2014. Due to the high amount of carbon and diffusible hydrogen, high-strength wear-resistant steel NM360, which is widely used on excavating machinery, always tends to develop cold crack after welding. Heat affected zone (HAZ) is the weakest part in a welding joint and is the most probable location for ...
متن کاملBond of High Strength Concrete with High Strength Reinforcing Steel
This paper presents a study about the bond of high strength concrete with high strength steel. Fourteen pull out tests were carried out to determine the bond. The concrete strength was about 70 MPa and the steel was a 500 MPa grade. Bar diameters used were 12, 16, 20, 25, 28, 32 and 36 mm. In order to investigate the effect of cover, each test was done twice, once in a 240 mm diameter concrete ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Manufacturing Technology
سال: 2018
ISSN: 1213-2489,1213-2489
DOI: 10.21062/ujep/58.2018/a/1213-2489/mt/18/1/84