Welding Metallurgy of Steels

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Problems in Repair-welding of Duplex-treated Tool Steels

Castings of aluminum and plastics are of high importance in the industrial world. They are usually made using permanent metallic moulds for pressure die-castings and injection molding. Die-tools are usually produced from chromium maraging hot work tool steel and are heat treated to hardness between 29 and 48 HRC, 1-3 . Die life is a mayor factor of a die-casting process and it strongly affects ...

متن کامل

Laser welding of modern automotive high strength steels

The paper demonstrates the correlation between the chemical composition of steel grades and the hardness as well as the formability of laser welds generated with modern automotive high strength steel grades. At the very low heat input of industrial laser welding and the resulting extremely high cooling rate, the weld hardness is fully controlled by the carbon content of the base materials and n...

متن کامل

Resistance Spot Welding of Steels: Modeling and Simulation

Resistance spot welding (RSW) includes many variables that can influence the weld properties. The purpose of this study is to develop an analytical model for prediction of thermal history and weld microstructure in RSW and to find the most important process parameters that influence the weld microstructure. A one dimensional model is proposed for prediction about thermal history during cooling ...

متن کامل

Welding residual stresses in ferritic power plant steels

Many of the degradation mechanisms relevant to power plant components can be exacerbated by stresses that reside within the material. Good design or structural integrity assessments require therefore, an accounting of residual stresses, which often are introduced during welding. To do this it is necessary to characterise the stresses, but this may not be possible in thick components using non-d...

متن کامل

Determination of Transformation Induced Heat Transfer Coefficients in Mechanical Properties of Powder Metallurgy Steels

Powder metallurgy has been used for the manufacture of fully dense, which have not reacted composites consisting of a matrix of copper containing 50 -60 vol% particles with negative thermal ZrW2O8 expansion. On cycling between 25 and 300°C, the compounds showed coefficients thermal expansion which varies rapidly with temperature and significantly larger than expected by theory. Improvements in ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: JOURNAL OF THE JAPAN WELDING SOCIETY

سال: 2009

ISSN: 0021-4787,1883-7204

DOI: 10.2207/jjws.78.414