Wear-resistant nickel-based laser clad coatings for high-temperature applications
نویسندگان
چکیده
منابع مشابه
Microstructure and Wear Resistance of Laser-Clad (Co, Ni)61.2B26.2Si7.8Ta4.8 Coatings
Key Laboratory of Materials Modification by Laser, Ion and Electron Beams (Ministry of Education), School of Materials Science and Engineering, Dalian University of Technology, Dalian 116024, China; [email protected] (L.Z.); [email protected] (S.Q.); [email protected] (Q.Y.) * Correspondence: [email protected] (C.W.); [email protected] (C.D.); Tel.: +86-0411-8470-8449 (C.W.)...
متن کاملMicro-Structures and High-Temperature Friction-Wear Performances of Laser Cladded Cr–Ni Coatings
Cr-Ni coatings with the mass ratios of 17% Cr-83% Ni, 20% Cr-80% Ni and 24% Cr-76% Ni were fabricated on H13 hot work mould steel using a laser cladding (LC). The surface-interface morphologies, chemical elements, surface roughness and phase composition of the obtained Cr-Ni coatings were analysed using a scanning electron microscope (SEM), energy disperse spectroscopy (EDS), atomic force micro...
متن کاملSelf-lubricating, low-friction, wear-resistant Al-based quasicrystalline coatings
After gas atomization, a quasicrystalline powder based on aluminium was used to prepare a thick coating by high-velocity oxygen-fuel flame torch spraying. This layer was deposited on top of a bond-coat layer on a steel plate. A post-spraying annealing treatment turned the two layers to their stable state, a γ-brass crystal and an icosahedral quasicrystal, respectively. The projection parameters...
متن کامل2.B Perfluorinated Copolymer Coatings for High-Power Laser Applications
Many common crystals for optical parametric processing, i.e., KDP, CDA, etc., are hygroscopic. Preserving their long-tenn stability and optical quality requires immersion in an index-matching liquid contained in some sort of cell.' Several drawbacks derive from this, not the least of which is cost, when up to 1-m beam and cell diameters must be considered for use in fusion-scale laser systems. ...
متن کاملThick Sputtered Tantalum Coatings for High-Temperature Energy Conversion Applications
Thick sputtered tantalum (Ta) coatings on Inconel were investigated as a potential replacement for bulk refractory metal substrates used for high-temperature emitters and absorbers in thermophotovoltaic energy conversion applications. In these applications, high-temperature stability and high reflectance of the surface in the infrared wavelength range are critical in order to sustain operationa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Letters on Materials
سال: 2019
ISSN: 2218-5046,2410-3535
DOI: 10.22226/2410-3535-2019-4-470-474