Wear Performance of UHMWPE and Reinforced UHMWPE Composites in Arthroplasty Applications: A Review
نویسندگان
چکیده
منابع مشابه
Wear Reduction in Total Ankle Arthroplasty Using Highly Crosslinked UHMWPE
Introduction: Bearing couples within total ankle arthroplasty (TAA) typically utilize cobalt chromium alloys articulating on ultrahigh molecular weight polyethylene (UHMWPE). Articulation of these surfaces during in vivo loading can generate UHMWPE wear particles, which may then result in osteolysis and component loosening [1]. Osteolysis has been observed following TAA in 15-22% of patient pop...
متن کاملWear of retrieved UHMWPE hip liners.
After the gamma-irradiation sterilization, the most widely used orthopaedic grade polymer bearing liner material for the total joint replacement, ultra-high molecular weight polyethylene (UHMWPE), degrades through the progressive in vivo oxidation. The oxidative degradation makes UHMWPE brittle and leads to reduction of its mechanical properties. In this study, the effect of the in vivo post-ir...
متن کاملDifferences in the Sliding Wear Track Patterns Between UHMWPE/Steel and UHMWPE/CNx Pairs
This work explores the effect of surface modification of stainless steel with a carbon nitride (CNx) film, under sliding wear of the UHMWPE/steel. Wettatibility of CNx coatings is assessed by means of the sessile drop method using two different liquid media. Microhardness and stiffness of CNx coatings are estimated by depth-sensing indentation. The sliding performance of UHMWPE against stainles...
متن کاملPMMA Third-Body Wear after Unicondylar Knee Arthroplasty Decuples the UHMWPE Wear Particle Generation In Vitro
INTRODUCTION Overlooked polymethylmethacrylate after unicondylar knee arthroplasty can be a potential problem, since this might influence the generated wear particle size and morphology. The aim of this study was the analysis of polyethylene wear in a knee wear simulator for changes in size, morphology, and particle number after the addition of third-bodies. MATERIAL AND METHODS Fixed bearing...
متن کاملDevelopment and Investigation of Mechanical Properties of PEEK Fine Particles Reinforced UHMWPE Composites
In the present work, novel Ultra-high molecular weight polyethylene (UHMWPE) composites reinforced with 3wt. %, 6wt. %, 9wt. %, 12wt. % and 15wt. % PEEK particles are fabricated by using hot compression moulding technique and mechanical properties are investigated. Experiments were conducted as per ASTM standards to evaluate the properties of tensile, flexural, impact, and microhardness. The re...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Lubricants
سال: 2015
ISSN: 2075-4442
DOI: 10.3390/lubricants3020413