Wear load capacity of crossed helical gears with wheel made from sintered steel
نویسندگان
چکیده
منابع مشابه
Sintered Steel Composites Reinforced with Ceramic Nanoparticles: Fabrication, Characteristics and Wear Behavior
Steel composites reinforced with alumina nanoparticles were prepared by powder metallurgy process. Samples containing two different amounts of carbon (0.35 and 0.55 wt.%) and 0-5 wt.% Al2O3 nanoparticles were fabricated by mixing, compacting and sintering of diffusion bonded Distaloy AE powder. The density, hardness and wear tests were performed on the prepared samples. Fu...
متن کاملEfficiency and wear properties of spur gears made of powder metallurgy materials
|III Abstract Powder metallurgy (PM) is usually used in manufacturing parts with complex geometries, such as gears and structural parts. The main attractions of PM are the high rate of material utilization, environmental friendliness of production, economic advantages (especially for complex geometries), and possibility of obtaining lighter components. To find a wide range of applications and c...
متن کاملA STUDY ON WEAR RATES OF 100Cr6 STEEL RUNNING AGAINST SINTERED STEEL SURFACES UNDER DRY AND STARVED LUBRICATION
This paper investigates the tribological behavior of 100Cr6 steel pin running against sintered steel bearing material used in hermetic compressors. Tests were conducted under dry and starved lubrication sliding conditions in air at room temperature. Although porous structure acts as crack initiation sites thus limiting the wear resistance of sintered iron in dry sliding conditions under high co...
متن کاملUltimate Load Capacity and Behavior of Thin-Walled Curved-Steel Square Struts, Subjected to Compressive Load
There have been some experimental tests on hollow curved-steel struts with thin-walled square sections, in order to investigate their general behavior, particularly their capacity for bearing differing loads. One set of square tubes are cold-formed into segments of circular arcs with curvature radii, equal to 4000 mm. Different lengths of curved struts are fabricated so as to cover a practical ...
متن کاملEvaluation of load capacity of gears with an asymmetric tooth profile
Background: An ISO standard tooth profile has a symmetric pressure angle of 20°. However, the load capacity can be increased with respect to bending and contact pressure by increasing the pressure angle on the meshing side of an asymmetric tooth. Accordingly, we analyzed the torque transmission capacity of asymmetric gears with various pressure angles. Methods: We calculated the deflection and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science of Sintering
سال: 2015
ISSN: 0350-820X,1820-7413
DOI: 10.2298/sos1502153m