WEAR CHARACTERISTICS OF Cu OFHC MATERIAL PREPARED BY ORBITAL FORGING AND ECAP
نویسندگان
چکیده
منابع مشابه
Dry and Wet Wear Characteristic of TiO2 Thin Film Prepared by Magnetic Sputtering in Ringer Solution
In this research, a thin film of TiO2 was applied on AZ91D using the method of magnetic sputtering. Microstructure investigations were done using field emission scanning electron microscope (FESEM) and X-ray diffraction (XRD). Wear resistance for the coating was investigated using the pin on the disk in the form of dry and in the Ringer's solution. After this test, the worn surface of the sampl...
متن کاملNumerical and Experimental Investigation of Cold orBital Forging of a 16MnCr5 Alloy Spur Bevel Gear
The purpose of this research is to analyze the forging of bevel gears based on conventional forging method with material number 1.7131 with finite element method by means of SUPER FORGE software and to compare it with experimental cold orbital forging results.After doing simulation of conventional forging and obtaining press tonnage due to orbital forging method with DEFORM software, orbital fo...
متن کاملMechanical Properties and Microstructure Development of Ultrafine-grained Cu Processed by ECAP
Technical purity Cu (99.95 wt%) polycrystals have been processed at room temperature by equal channel angular pressing. The results of mechanical tests and the microstructure characterization by various experimental techniques are presented. The yield stress as well as the strength were shown to increase with increasing strain and exceed the respective values of a coarse-grained material. The m...
متن کاملMagnetic Properties and Structural Study of Ni-Co/Cu Multilayers Prepared by Electrodeposition Method
Ni-Co/Cu multilayers have been grown by electrodeposition method from a single electrolyte (based on Ni(SO4).6H2O, Co(SO4).7H2O, Cu(SO4) and H3BO3) using galvanostatic control on titanium sublayers. The X-ray diffraction (XRD) patterns confirmed the multilayered structure with the nanometer thicknesses. Also, electron diffraction x-ray (EDX) analysis confirmed the purity of deposited samples. ...
متن کاملDry Wear Behavior of 42CrMo4 Steel/ZrO2 Composite Prepared by Pressure-Less Infiltration Method
The aim of this research was to study the wear behavior of 42CrMo4 steel/ZrO2 composite with 10 and 30 ppi performed ceramic and compare it with the un-reinforced steel under different applied loads. The composite specimens were obtained by pressureless infiltration of the melt into a preformed ceramic of zirconium oxide. The effect of applied load on the specimens wear behavior was ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Modern Physics B
سال: 2010
ISSN: 0217-9792,1793-6578
DOI: 10.1142/s0217979210064435