Wear behavior of cold pressed and sintered Al2O3/TiC/CaF2-Al2O3/TiC laminated ceramic composite
نویسندگان
چکیده
منابع مشابه
Sintered hydroxyapatite ceramic for wear studies.
A sintered hydroxyapatite (HAP) ceramic for use in wear studies was prepared from a commercial tricalcium phosphate. The sintered HAP had physical properties close to those of human enamel. The coefficient of friction and wear of the sintered HAP ceramic as characterized by tangential force, track width, and surface failure data, approximated those of human enamel.
متن کاملSintered Steel Composites Reinforced with Ceramic Nanoparticles: Fabrication, Characteristics and Wear Behavior
Steel composites reinforced with alumina nanoparticles were prepared by powder metallurgy process. Samples containing two different amounts of carbon (0.35 and 0.55 wt.%) and 0-5 wt.% Al2O3 nanoparticles were fabricated by mixing, compacting and sintering of diffusion bonded Distaloy AE powder. The density, hardness and wear tests were performed on the prepared samples. Fu...
متن کاملDensification and Deformation Behavior of Sintered P/M Zinc-Zinc Oxide Composite during Cold Upsetting
Studies were carried out to evaluate the initially preformed density and initial aspect ratio on the densification behavior of sintered Zinc and Zinc Oxide composite. The preform possessed 0.85 is the initial density. Aspect ratio for three different oxidizing temperatures (at 150°C, 200°C and 250°C) varied from 0.4 to 0.85. Properties of Zinc-Zinc Oxide composites with respect to linear strain...
متن کاملMicrostructure and Phase Composition of Cold Isostatically Pressed and Pressureless Sintered Silicon Nitride.
The microstructure and physical properties of new Y2O3 and Al2O3 oxide-doped silicon nitride ceramics fabricated by cold isostatic pressing and free sintering were investigated. The phase composition of produced material was also studied by X-ray diffraction at room and elevated temperature. The fabricated ceramics featured a microstructure of Si5AlON7 grains with a fine-grained α-Si3N4 with a ...
متن کاملMicrostructure and Dry-Sliding Wear Behavior of B4C Ceramic Particulate Reinforced Al 5083 Matrix Composite
B4C ceramic particulate–reinforced Al 5083 matrix composite with various B4C content was fabricated successfully via hot-press sintering under Argon atmosphere. B4C particles presented relative high wettability, bonding strength and symmetrical distribution in the Al 5083 matrix. The hardness value, friction coefficient and wear resistance of the composite were higher than those of the Al 5083 ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Metallurgica Sinica (English Letters)
سال: 2013
ISSN: 1006-7191,2194-1289
DOI: 10.1007/s40195-012-0247-5