Wear Behavior of Al-based Composites according to Reinforcements Volume Fraction
نویسندگان
چکیده
منابع مشابه
Significantly enhanced creep resistance of low volume fraction in-situ TiBw/Ti6Al4V composites by architectured network reinforcements
We present a new class of TiBw/Ti6Al4V composites with a network reinforcement architecture that exhibits a significant creep resistance compared to monolithic Ti6Al4V alloys. Creep tests performed at temperatures between 773 K and 923 K and stress range of 100 MPa-300 MPa indicate both a significant improvement of the composites creep resistance due to the network architecture made by the TiB ...
متن کاملDevelopment of in-Situ Al-Si/CuAl2 Metal Matrix Composites: Microstructure, Hardness, and Wear Behavior
In the present work, in-situ metal matrix composites were fabricated through squeeze casting. The copper particles were dispersed with different weight percentages (3%, 6%, 10%, and 15%) into Al-12% Si piston alloy. Also, heat treatments were performed at 380 °C and 450 °C for holding times of 6 and 18 h. The microstructures, X-ray diffractometer (XRD) pattern, hardness, and wear characteristic...
متن کاملWear behavior of Al-7%Si-0.3%Mg/melon shell ash particulate composites
The present study examined wear characteristics of A356/melon shell ash particulate composites. Dry-sliding the stainless steel ball against specimen disc revealed the abrasive wear behavior of the composites under loads of 2 and 5N. The composite showed lower wear rate of 2.182 × 10-4 mm3/Nm at 20 wt% reinforced material under load of 5N. Results showed that wear rate decreased significantly w...
متن کاملMechanism-Based FE Simulation of Tool Wear in Diamond Drilling of SiCp/Al Composites
The aim of this work is to analyze the micro mechanisms underlying the wear of macroscale tools during diamond machining of SiCp/Al6063 composites and to develop the mechanism-based diamond wear model in relation to the dominant wear behaviors. During drilling, high volume fraction SiCp/Al6063 composites containing Cu, the dominant wear mechanisms of diamond tool involve thermodynamically activ...
متن کاملEffect of fiber volume fraction and length on the wear characteristics of glass fiber-reinforced dental composites.
OBJECTIVE The main objective of this study was to evaluate the wear characteristics of fiber-reinforced dental composites. Variables under investigation include the fiber weight percent added to the matrix as well as fiber length. METHODS Dental specimens with glass fiber content of 2, 5.1, 5.7, and 7.6 wt% with fiber length of either 1.5 or 3 mm, were prepared by mixing an activated dental r...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Korea Society For Power System Engineering
سال: 2011
ISSN: 1226-7813
DOI: 10.9726/kspse.2011.15.5.077