Wave Mode Identification of Acoustic Emission Signals Using Phase Analysis
نویسندگان
چکیده
منابع مشابه
Cluster Analysis of Acoustic Emission Signals for Carbon/Epoxy Composite in Four-point Bending Test (RESEARCH NOTE)
Due to the extensive use of composites in various industries and the fact that defects reduce ultimate strength and efficiency during operation, detection of failures in composite parts is very important. The aim of this paper is to use Acoustic Emission (AE) non-destructive method in four-point bending test of carbon/epoxy composite to analyze and examine the failure mechanisms. This method is...
متن کاملBearing Fault Detection Using Acoustic Emission Signals Analyzed by Empirical Mode Decomposition
In condition monitoring of ball bearings, traditional techniques involving vibration, acceleration may not be able to detect a growing fault due to the low impact energy generated by the relative motion of the components. This study presents an experimental evaluation for incipient fault detection of lightly loaded ball bearings by using acoustic emission method. A table top bearing test rig is...
متن کاملStudy of the Frictional Surface Damage Using Acoustic Emission Method
In this study, the change at rubbing surfaces has been investigated experimentally using an acoustic emission signal monitoring system. A steel ring is slipped on the surface of a metallic sheet to simulate frictional conditions. The mechanical disturbances caused by the movement of the ring produce stress waves propagating along the sheet surface. The out of plane displacement of the sheet su...
متن کاملWavelet analysis of acoustic emission signals in boring
Using acoustic emission (AE) signals to monitor tool wear states is one of the most eective methods used in metal cutting processes. As AE signals contain information on cutting processes, the problem of how to extract the features related to tool wear states from these signals needs to be solved. In this paper, a wavelet packet transform (WPT) method is used to decompose continuous AE signals...
متن کاملAssessment of Laser Cutting Quality Using Acoustic Emission Signals
The paper gives an analysis of acoustic-emission signals measured in the course of laser cutting of steels plates DC04 and X5CrNi18-10. Laser cutting is a process in which there can be a wide range of cutting parameters, but nevertheless cutting of plate products can be accomplished. Within the range of the parameters concerned, however, the quality of a cut edge can vary quite strongly; laser-...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acoustics
سال: 2019
ISSN: 2624-599X
DOI: 10.3390/acoustics1020026