Water Splitting: Vapor Phase Fabrication of Nanoheterostructures Based on ZnO for Photoelectrochemical Water Splitting (Adv. Mater. Interfaces 18/2017)

Controlled fabrication of Sn/TiO2 nanorods for photoelectrochemical water splitting

In this work, we investigate the controlled fabrication of Sn-doped TiO2 nanorods (Sn/TiO2 NRs) for photoelectrochemical water splitting. Sn is incorporated into the rutile TiO2 nanorods with Sn/Ti molar ratios ranging from 0% to 3% by a simple solvothermal synthesis method. The obtained Sn/TiO2 NRs are single crystalline with a rutile structure. The concentration of Sn in the final nanorods ca...

Efficiency limits for photoelectrochemical water-splitting

Theoretical limiting efficiencies have a critical role in determining technological viability and expectations for device prototypes, as evidenced by the photovoltaics community's focus on detailed balance. However, due to their multicomponent nature, photoelectrochemical devices do not have an equivalent analogue to detailed balance, and reported theoretical efficiency limits vary depending on...

Water Splitting: One‐dimensional TiO2 Nanotube Photocatalysts for Solar Water Splitting (Adv. Sci. 1/2017)

InGaN-based photoanode with ZnO nanowires for water splitting

The water splitting properties of InGaN photoanodes equipped with ZnO nanowires were examined in this study. Over the solar spectrum range, the absorbance exhibited a remarkable increase due to the enhanced light absorption caused by the ZnO nanowires. By varying the ZnO nanowires length, the photo-to-current density of photoanodes was increased from 0.017 to 0.205 mA/cm2 at 1.23 V versus rever...

Design of Compact Photoelectrochemical Cells for Water Splitting

Solar driven water splitting can be achieved by coupling electrolyzers with PhotoVoltaics (PV). Integration of both functions in a compact PhotoElectroChemical (PEC) cell is an attractive option but presents significant scientific challenges. In this work, the design of singleand dualcompartment PEC cells for research purposes is discussed. The fabrication of separator-electrode assemblies is a...