Water Pool boiling on Aluminum Metal Foams

Pool Boiling Heat Transfer in Water/Amines Solutions

In this investigation, nucleate boiling heat transfer coefficients were experimentally measured during pool boiling of mixtures, consisting of water/monoethanolamine and water/diethanolamine on a horizontal heating rod, under atmospheric pressure. The experiment was carried out below 205 kW.m-2 heat flux, over a wide range of concentrations. These experiments include, measurement of pool boilin...

Pool boiling from GEWA surfaces in water and R-113

This reproduction was made from a copy of a manuscript sent to us for publication and microfilming. While the most advanced technology has been used to pho­ tograph and reproduce this manuscript, the quality of the reproduction is heavily dependent upon the quality of the material submitted. Pages in any manuscript may have indistinct print. In all cases the best available copy has been filmed....

Secondary pool boiling effects

Pool boiling of water-Al2O3 and water-Cu nanofluids on horizontal smooth tubes

Experimental investigation of heat transfer during pool boiling of two nanofluids, i.e., water-Al2O3 and water-Cu has been carried out. Nanoparticles were tested at the concentration of 0.01%, 0.1%, and 1% by weight. The horizontal smooth copper and stainless steel tubes having 10 mm OD and 0.6 mm wall thickness formed test heater. The experiments have been performed to establish the influence ...

Creep of aluminum syntactic foams

Aluminum syntactic foams with densities of 1.2–1.5 g/cm3 were deformed at 500 ◦C under constant uniaxial compressive stresses ranging from to 14 MPa. The foam creep behavior is characterized by a short primary stage and a long secondary stage where the strain rate is constant and inimum, followed by a tertiary stage at high stresses. The minimum strain rate varies with stress according to an ap...