Wall-Less Like Reactor : Simulation and Experimental Results
نویسندگان
چکیده
منابع مشابه
simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Less than Best Effort: Application Scenarios and Experimental Results
In this article we present the work done to study the potential benefits to end users and network operators and the feasibility of deploying a Less than Best Effort (LBE) service on a wide area scale. LBE is a Per-Domain Behaviour based on the Differentiated Services Quality of Service architecture. We present a brief overview of the evolution of the case for LBE, through the IETF DiffServ WG a...
متن کاملBehavior Simulation Polyamide 6 (PA6) During Friction Stir Welding and Comparison with Experimental Results
In this study, the effects of linear speed and rotational speed of the friction stir welding tool was investigated on the heat generation and distribution of heat,the material flow and weld defect formation of the Polyamide 6 (PA6) workpiece. The commercial CFD Fluent 6.4 software package was used to the simulation of the process with computational fluid dynamic technique. The output results of...
متن کاملNumerical simulation of in-cylinder tumble flow field measurements and comparison to experimental results
This paper presents a comparison between measured and predicted results of the in-cylinder tumble flow and the flow coefficient generated by a port-valve-liner assembly on a steady-flow test bench. In this study, computational fluid dynamics (CFD) methods were employed to gain further insight into characteristics of an engine. The purpose was to advance understanding of the stationary turbulenc...
متن کاملBehavior Simulation Polyamide 6 (PA6) During Friction Stir Welding and Comparison with Experimental Results
In this study, the effects of linear speed and rotational speed of the friction stir welding tool was investigated on the heat generation and distribution of heat,the material flow and weld defect formation of the Polyamide 6 (PA6) workpiece. The commercial CFD Fluent 6.4 software package was used to the simulation of the process with computational fluid dynamic technique. The output results of...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Le Journal de Physique IV
سال: 1995
ISSN: 1155-4339
DOI: 10.1051/jphyscol:1995535