Wafer Level Packaging to Address Future Direct Chip Attach Needs

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Printable Die Attach Adhesives for Substrate-On-Chip Packaging

The dominant trend in packaging DDR DRAM for the future is the face down substrate-on-chip configuration. For this type of package it is critical that the die attach method employed provide precise control of bond line thickness and die tilt, minimal fillet, and prevent contamination of the wire bond pads located on the edge of the center wire bond channel. To date, a film adhesive has been the...

متن کامل

Wafer-Level Packaging For RF Passive Integration

Wafer-level packaging (WLP) technology offers novel opportunities for the realisation of highquality on-chip passives needed in RF front-ends. IMEC proposes thin-film WLP technology in combination with 90nm CMOS as a cost-effective approach to integrate RF and microwave systems. The potential of this technology is assessed by means of two demonstrator sub-circuits: a low-power voltage-controlle...

متن کامل

Wafer Level Packaging with Wedge Seal Method

Wafer level packaging could reduce the cost of MEMS based sensors through simplified processing and inexpensive components. A novel vacuum tight seal referred to as the wedge seal method is proposed in this paper. The seal consists of a silicon wedge forced into a pliable material (typically a metal) that is attached to the component wafer. The wedge-seal addresses some of the requirements of m...

متن کامل

Wafer-Level Micro/Nanosystems Integration and Packaging

Micro/nanosystems have attracted considerable interests and seen significant advances over the years. The huge gap between technology development and commercialization can be largely attributed to the challenges faced in the integration and packaging of the devices. The packaging has to work around the diverse functional requirements while ensuring that the device is able to perform effectively...

متن کامل

Wafer-Level Vacuum Packaging of Smart Sensors

The reach and impact of the Internet of Things will depend on the availability of low-cost, smart sensors-"low cost" for ubiquitous presence, and "smart" for connectivity and autonomy. By using wafer-level processes not only for the smart sensor fabrication and integration, but also for packaging, we can further greatly reduce the cost of sensor components and systems as well as further decreas...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Transactions of The Japan Institute of Electronics Packaging

سال: 2012

ISSN: 1883-3365,1884-8028

DOI: 10.5104/jiepeng.5.85