Visualization of the Coated Electrode Welding
نویسندگان
چکیده
منابع مشابه
Determination of Captopril using platinum coated nanoporous gold film electrode
In this article electrochemical determination of captopril at the surface of the platinum coated nanoporous gold film (PtNPGF) electrode is reported using the cyclic voltammetry and amperometry. For the preparation of PtNPGF, the surface of NPGF electrode was covered with Cu layer using underpotential electrochemical deposition (UPD).Afterward, the copper layer is replaced with platinum ions vi...
متن کاملTušek: Bridging of Welding Gaps in Welding with a Multiple-wire Electrode
An investigation on bridging larger welding gaps between workpieces occurring in practice due to structural requirements or to defects in weld edge preparation is described. Some characteristic cases from practice where a larger root gap should be bridged or the space between two or three workpieces should be filled with a greater quantity of filler material are described. Submerged-arc welding...
متن کاملModelling of Electrode-arc Coupling in Electric Arc Welding
Modelling of the arc in electric arc welding is significant to achieve a better process understanding, thus gain better weld quality and a more efficient production process. It requires knowing the conditions at the surfaces of the anode and cathode. These conditions are very difficult to set from measurements and should be calculated. This requires modelling the complex physics of the electrod...
متن کاملAutomation of Manufacturing Welding Electrode Extruder Control Panel with PLC
The manual process of manufacturing the welding electrode takes more time and work. It also occupies more space for the control panel with the installation of PLC in the welding electrode manufacturing control panel the size of the panel is reduced to the great extent. It has reduced the cost of the panel and has increased the rate of the production. Here the entire process of electrode manufac...
متن کاملKeyhole behaviour during laser welding of zinc-coated steel
The production of consistent, high-quality laser welds on zinc-coated steels for the automotive industry remains a challenge. A simple overlap joint geometry is desirable in these applications but has been shown to be extremely detrimental to laser welding because the zinc vapour formed at the interface between the two sheets expands into the keyhole and disrupts fluid flow in the melt pool, wh...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Universitatis Agriculturae et Silviculturae Mendelianae Brunensis
سال: 2016
ISSN: 1211-8516,1211-8516
DOI: 10.11118/actaun201664010043