Vibroacoustic diagnostics of surface electron beam alloying process of ferritic stainless steel

Quantification of ridging in ferritic stainless steel sheets by electron backscattered diffraction R-value maps.

In ferritic stainless steel (FSS), undesirable surface defects of ridging appear during deep drawing. The formation of these defects is attributed to the inhomogeneous distribution of orientations of individual grains. In the present work, a new electron backscattered diffraction R(α)-value map was introduced, and the dependence of the tensile directions on the formation of ridging in an FSS sh...

Precipitation sequence in niobium-alloyed ferritic stainless steel

Niobium is an important alloying element in the design of heat-resistant ferritic stainless steels for automotive exhaust systems. When in solid solution, it improves both the high temperature strength and the resistance to thermal fatigue. However, it also forms several kinds of precipitates during service. These reactions have been modelled, taking into account the multicomponent nature of th...

The Influence of Homogenization and Solution Annealing Process on the Microstructure and Mechanical Properties of 1.4470 Ferritic-austenitic Stainless Steel

In the present research, the effect of the homogenization process and annealing temperature were investigated for the 1.4470 ferritic-austenitic stainless steel in the as-cast condition. In this regard, microstructural evolutions, hardness, and impact energy of the steel was evaluated with different heat treatment conditions. The results show that the minimum volume fraction of austenite phase ...

External corrosion resistance of steel and ferritic stainless steel exhaust systems

The exhaust system has a number of requirements to fulfil. The major ones are to reduce the noise level created by the engine, to channel the waste gases out the rear of the automobile, to minimize the reduction in engine performance, and to have an acceptable service life and cost1. The exhaust system is divided into two main parts, the hot end and the cold end. The components comprising the h...

Chemical Surface Treatment of Stainless Steel