Vibrational Excitation of Cylindrical Involute Gears Due to Tooth Form Error
نویسندگان
چکیده
منابع مشابه
Optimal Selection of Addendum Modification Coefficients of Involute Cylindrical Gears
Based on the principles of equalized sliding coefficients and equalized teeth bending strength, the optimization mathematical model for calculating and allocating the addendum modification coefficients of involute cylindrical gear is firstly established. Then the measures to calculate the tooth parameters in real-time during the optimization steps are achieved. Finally, the optimization program...
متن کاملBending strength simulation of asymmetric involute tooth gears
In order to enhance the load capacity of gears, researchers take notice in the asymmetric tooth gears. Asymmetric gear which has higher pressure angle of back tooth aiming to improve banding strength has been analyzed (Deng, et al., 2003). Brown et al. (Brown, et al., 2010) investigate the asymmetric tooth from both point of view of bending and scuffing. Kruger et al. (Kruger et al., 2013) anal...
متن کاملModal Analysis of Cylindrical Gears with Arcuate Tooth Trace
In this paper, the forming principle, meshing features and tooth surface equation were introduced. And the modal parameters distribution of cylindrical gears with arcuate tooth trace was researched. The results show: 1. The modulus was the biggest impact factor for modal and natural frequency of cylindrical gears with arcuate tooth trace, then tooth width, and the radius of tooth line have the ...
متن کاملCutting Kinematics Analysis in Hypocycloidal Tooth Milling of Cylindrical Gears
The hypocycloidal flanks of the cylindrical gear teeth have the flank lines defined by lengthened or shortened hypocycloid and the profile involute. The curved and bulged flanks have some advantages, among them being the increased strength in bending and controlled positioning of the contact imprint. The tooth flank generation has on the basis the application of the technological process of mil...
متن کاملSpatial involute gearing - a new type of skew gears
This is a geometric approach to spatial involute gearing which has recently been developed by Jack Phillips [4]. Due to Phillips' fundamental theorems helical involute gears for parallel axes (Fig. 2) serve also as tooth flanks for a uniform transmission between skew axes, and the transmission ratio is even independent of the relative position of the axes.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of JSME
سال: 1980
ISSN: 0021-3764,1881-1426
DOI: 10.1299/jsme1958.23.1536