Vibration Intensity Measurement Using Three Accelerometers.
نویسندگان
چکیده
منابع مشابه
Measurement Model and Precision Analysis of Accelerometers for Maglev Vibration Isolation Platforms
High precision measurement of acceleration levels is required to allow active control for vibration isolation platforms. It is necessary to propose an accelerometer configuration measurement model that yields such a high measuring precision. In this paper, an accelerometer configuration to improve measurement accuracy is proposed. The corresponding calculation formulas of the angular accelerati...
متن کاملOptimal Placement of Triaxial Accelerometers for Modal Vibration Tests
Proper pretest planning is a vital component of any successful vibration test. An extremely important part of the pretest exercise is the placement of sensors, usually in the form of accelerometers. The accelerometers must be placed such that all of the important dynamic information is obtained during the course of the test. The resulting sensor configuration must be optimal in some sense such ...
متن کاملStator Bar Vibration Sensors and Fiber-Optic Accelerometers
Vibration analysis has been conducted on large rotating machines for many decades. Proximity probes and accelerometers are traditionally used to measure bearing and shaft vibration in an effort to keep mechanical condition in check. Simple measurement of amplitude, to the more complex analysis such as Fast Fourier Transforms, are made by maintenance personnel in an effort to identify the source...
متن کاملA New Solution for Shock and Vibration Calibration of Accelerometers
Shock and vibration phenomena are present around us in everything that moves. The accelerometer is a class of instruments commonly used to measure that motion, producing an electrical output signal related to the applied motion. Accurate accelerometer calibration is a way to provide physical meaning to this electrical output and it is a prerequisite for quality motion measurements. Systems and ...
متن کاملMeasurement of Bunch Length Using Intensity Interferometry
Abstract Intensity interferometry is one of the most conventional methods for measuring the length of a short light pulse (from ps to sub-ps). We attempted to apply this method to the measurement of bunch length at the Photon Factory. We tested both the second-harmonic autocorrelation method and the two-photon interference method. With both methods, we observed the autocorrelation signal of the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1993
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.59.445