Vibration analysis of a gear train system with elastically supported shafts.
نویسندگان
چکیده
منابع مشابه
Characterizing the vibration of an elastically point supported rectangular plate using eigensensitivity analysis
Normalized frequencies are computed for a rectangular, isotropic plate resting on elastic supports. The normalized frequencies are determined using eigensensitivity analysis, which approximates the eigenparameters in a Mauclarin series, yielding an approximate closed-form expression. One benefit of the approximate closed-form expression is its computational efficiency and yet another is its app...
متن کاملActive Vibration Control of Gear Transmission System
In this paper, an active control structure used piezoelectric stack actuator is built to suppress vibration due to internal incentive in gear transmission. Because the gear system is timevariant and unknown, an offline modeling technique is unable to tracking the changes in the secondary path, an adaptive filter algorithm used online secondary path modeling method is proposed to the active vibr...
متن کاملMathematical Model and Vibration Analysis of Aircraft with Active Landing Gear System using Linear Quadratic Regulator Technique
This paper deals with the study and comparison of passive and active landing gear system of the aircraft and dynamic responses due to runway irregularities while the aircraft is taxying. The dynamic load and vibration caused by the unevenness of runway will result in airframe fatigue, discomfort of passengers and the reduction of the pilot’s ability to control the aircraft. One of the objectiv...
متن کاملDetection of Gear fault using vibration analysis
The new generation of condition monitoring and diagnostics systems differs by the detailed solution of diagnostic problems that allows making a step from machine vibration state monitoring to the monitoring of the machine technical condition. Most rotating machine defects can be detected by such a system much before dangerous situations occur. It allows the efficient use of stationary on-line c...
متن کاملAnalysis of a gear train using finite element modelling
Here the theoretical maximum contact stress is calculated by Hertz equation. Also the finite element analysis of spur gear is done to determine the maximum contact stress by ANSYS 14.5. It was found that the results from both Hertz equation and Finite Element Analysis are comparable. From the deformation pattern of steel and grey cast iron, it could be concluded that difference between the maxi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1985
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.51.2447