Varying CFRP workpiece temperature during slotting: Effects on surface metrics, cutting forces and chip geometry
نویسندگان
چکیده
منابع مشابه
Effects of cutting edge geometry, workpiece hardness, feed rate and cutting speed on surface roughness and forces in finish turning of hardened AISI H13 steel
In this study, the effects of cutting edge geometry, workpiece hardness, feed rate and cutting speed on surface roughness and resultant forces in the finish hard turning of AISI H13 steel were experimentally investigated. Cubic boron nitrite inserts with two distinct edge preparations and throughhardened AISI H13 steel bars were used. Four-factor (hardness, edge geometry, feed rate and cutting ...
متن کاملOptimization of Cutting Parameters on Tool Wear and Workpiece Surface Temperature in Turning of Aisi D2 Steel
A R T I C L E I N F O AISI D2 steel, Tool wear, Workpiece surface temperature, Taguchi method, Regression analysis. Received 19 July 2012 Accepted 29 August 2012 Available online 31 December 2012 Now-a-days increasing the productivity and the quality of the machined parts are the main challenges of metal cutting industry during turning processes. Optimization methods in turning processes, consi...
متن کاملDetermination of workpiece flow stress and friction at the chip–tool contact for high-speed cutting
This paper presents a methodology to determine simultaneously (a) the flow stress at high deformation rates and temperatures that are encountered in the cutting zone, and (b) the friction at the chip–tool interface. This information is necessary to simulate high-speed machining using FEM based programs. A flow stress model based on process dependent parameters such as strain, strain-rate and te...
متن کاملTemperature distribution in workpiece during scratching and grinding
The heat transfer problem of a moving heat source along the surface of a half space was studied analytically and numerically. For the 2D problem, the heat source was a strip moving source and for the 3D problem, the heat source was a square moving source. Analytical solutions are available only for adiabatic conditions as given by Carslaw and Jaeger [H.S. Carslaw, J.C. Jaeger, Conduction of Hea...
متن کاملMachinability evaluation of Titanium alloy in Laser Assisted Turning
The use of titanium and its alloys has increased in various industries recently, because of their superior properties of these alloys. Titanium alloys are generally classified as difficult to machine materials because of their thermo-mechanical properties such as high strength-to-weight ratio and low thermal conductivity. Laser Assisted Machining (LAM) improves the machinability of high strengt...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia CIRP
سال: 2019
ISSN: 2212-8271
DOI: 10.1016/j.procir.2019.09.021